No Flashers

[TwistedIllusionz]

Have a really strange problem. Both of my blinkers work just fine. Go to use the flashers though and they just stay on. Changed the flasher module, but with the same result. Any one have any thoughts and where to go from here. I checked, I think all of the grounds.

 

[Jgonick]

LEDs or regular light bulbs?

same flasher module type on both turn signal & hazards?

 

[RanchWelder]

The switch? Push button getting dirt and grime it ot and failing to release?

The LED's have to be capable of flashing nd they have to be inserted the correct way.
Try flipping them in the sockets, one at a time?

 

[Jgonick]

If LEDs- this video explains very well. It’s a jeep, but it’s the same for c/k10

Just making sure you know there are two flasher modules. Turn signal & hazards.


Elec flasher video

 

[TwistedIllusionz]

Didn't know there were 2. Where is the second one located? I do have LED, but they flash the correct speed.

 

[TwistedIllusionz]

Sorry for the late reply, but been busy lately and for some reason I'm not getting notifications from the forum. I will look into the electronic flasher, Thank you everyone for your help.

 

[Jgonick]

85- look to the right of the brake pedal. It's in the "convenience center"

 

[TotalyHucked]

My truck does the same thing. Did it with regular bulbs and still does it with LEDs. I've never looked into why. Turn signals work fine but hazards just stay on solid

 

[Jgonick]

It's between the brake pedal and gas pedal up high. Sort of difficult to get a picture of it.

 

[TotalyHucked]

It's between the brake pedal and gas pedal up high. Sort of difficult to get a picture of it.

Ya know, I remember seeing that one and wondering what it was for. I've already replaced the turn signal flasher. Guess I'll try this one next, thanks!

 

[TwistedIllusionz]

Thank you Jgonick. This second one was the problem. I have done all my own work on this truck, and I've never noticed that flasher down, lol. Thanks again