np205

  1. K

    Electronic Shift NP203/NP205 Doubler

    Hello everyone. Hope your Thanksgiving goes well. This will be my first posting on this site. I'm currently working on my dream truck build...a 1991 V3500 Crew Cab Cheyenne 4x4. Found it 2 years ago on FB marketplace and couldn't walk away from it. It's in rough shape, and it will be built from...
  2. R

    NP205 shift rail help!!

    NP205. Replacing the shift rail seals. Got the one shift rail closest to the transmission out, replaced seal, installed back in, put the roll pin back in and good to go. Now as far as the other rail, I can’t get it out!! I’ve removed the roll pin and have been pulling the crap out of it. Also...
  3. barrymattern

    C10 to K20 Body Swap – Driveline Issues

    TL;DR: I'm in the middle of body swapping a 1985 C10 cab & bed onto a 1984 K20 frame. The frame was purchased without a front clip, engine, or doors so specific truck options are not known. After decoding the VIN I confirmed the donor truck/frame is a Canadian truck that had a 6.2L diesel, and...
  4. iamtherealJayy

    ISO speedo driven gear NP205

    After searching for over a year and jb welding it twice I’m here hoping someone has a spare np205 that’s shot or something. I need the speedometer driven gear for the speedo cable from an np205. I believe it is stamped K but I’ll have to double check. I cannot find this part anywhere and my...
  5. Zayshley

    '76 K1500 NP203 to NP205 swap

    I just recently bought a NP205, that was bolted to a 400/th350 in a '80 Blazer, that I plan in putting in my truck to replace the beat NP203 which has the locking hubs conversion kit. Besides drive shafts, is there anything else I need to make it work?
  6. Powerhouse Ranch

    Looking for...

    Anybody know where a feller can find a couple rarities: Plastic floor np205 shift pattern Sierra Classic rear bedside badge for Jimmy Gas tank skid plate That's all for now, thanks
  7. Powerhouse Ranch

    NP205 Front Yoke U-bolt Strap Kit

    Direly need the u-bolt strap kit for front yoke on np205. Would also take the straps/bolts for front of front driveshaft onto 10 bolt diff. Thanks guys AND a yoke for my rear 10 bolt differential. All very important, i got what i could locally, i need you guys!
  8. Powerhouse Ranch

    NP205 Rear Yoke

    So i need a new yoke for the rear portion of my np205. Where's the best place to get one? Thanks
  9. Preston Tucker

    Whats it worth? 6 bolt housing 205

    Hey all! I want this transfer case, its a 6 bolt housing Np205 I found locally but i think the listed price is too high, whats it worth? It looks like its been spray-bombed for camera but quite frankly looks like crap.
  10. Preston Tucker

    HELP! Nv4500 Swap, so many transfer cases so little time.

    Ive been looking on here for hours and could not find a thread with the information I need, maybe you all can help! Anything is appreciated. I am converting my 1974 k25 from a burnt th350 to a Nv4500. I have all the hydro stuff for the cab out of an 87 parts rig and tonight I bought a whole...
  11. devin bianco

    quick question, full time to locking hubs (k10 10 bolt)

    I am doing the 203 to 205 swap on my 79, soon enough the front axle is going to be rebuilt and i know i will need t install a manual locking hub kit (currently has no hub locking mechanism). when i look it up, all i see is part time 203 kits that include the hubs. In this case will i just need a...
  12. devin bianco

    Np203 to Np205 , transfer case swap

    this might have been talked about before, but it would be nice for some clear information on it. first here are some specs: Ive got a 79 k10, sb350 going to a th350 going to a np203 full time no slip yoke. we are doing a np205 swap, we have the truck down to frame with no current drivetrain...
    • devin bianco
    • Thread
    • driveshafts help linkage np203 np205 np208 swap t-case th350 transfer case
    • Replies: 24
    • Forum: Transfer Case
  13. R

    Can't separate SM465 adapter from NP205 TCase

    Hi all, Tcase seems to be stuck to the coupler inside the adapter? Need some help on splitting the two for a rebuild.
  14. J

    A short intro...

    ...by another "new" guy. Long time lurker, forgot I hadn't posted an intro. I'm here to learn as much as I can soak up. I have a two-owner '77 GMC 1/2 ton 4x4, factory 350, Muncie SM465 with a NP205. I purchased it in '85 from the original owner who is a friend (so I know the history), and...

Latest posts

Forum statistics

Threads
44,411
Posts
956,918
Members
36,732
Latest member
blackmfcowboy
Top