lowered
-
Wanna slam that 63-98 C10/C1500? Lets talk about it!
Lowering your C10/C1500 (1963-1998) So, you want to lower your truck? Got questions about how/why/what to buy? Hopefully this will help with your decisions. I will try to address most of the common questions/issues and give you a good idea of what to look for and anything that will trip you up...- bluex
- Thread
- drop drop spindles dropped lower lowered slam slammed
- Replies: 65
- Forum: Lowered & Street Systems
-
I
Front bottoms out
I recently bought a 1974 c10 That was lowered by the previous owner ( unsure how much) I believe it’s 6 inches in the front and 7 or so in the rear. It was lowered in the rear by removing some leaves from the leaf springs. The front was lowered with drop spindles and lowering coils. I replaced...- Ivan Lopez
- Thread
- drop spindles dropped flip kit lowered
- Replies: 19
- Forum: Lowered & Street Systems
-
M
Belltech 4/6 Lowering kit with air bags for towing
Hey guys, I have an 85 c10 short step-side and am doing a 6'' drop, axle flip with belltechs c-notch. I want to be able to tow with my truck still. Has anyone here fabricated anything or know of a kit to run air bags with this set up? Thanks!- Michael85C10LQ9
- Thread
- 1985 4/6 6'' airbag belltech c10 dropped lowered towing
- Replies: 2
- Forum: Lowered & Street Systems
-
Wheel and tire size suggestion- C20 Camper Special conversion to C10
Anyone have any wheel suggestions on a 8 lug C20 suspension. Truck was once a camper special. 1978 but is now a slightly lowered short bed C10. Looking for suggestions on what wheels and tire size- I have seen wheel adapters to try and get down into 5 or 6 lug in order to open up more wheel... -
1986 Crew Cab Dually Project (need help finding it a new home)
1986 Chevy Crew cab Dually, Has had an easy life just used to pull our boat to the river and back. Low mile truck with lots of money spend on one off modifications including Custom front end that is portrayed in the rendering, has been test fitted. I will also consider including the molds for... -
Newbie to the Square world!
Excited to finally get my hands on a rust free square. I am originally from Minnesota where you can grab salt on your nearest road during the wintertime. Eats up the trucks pretty bad. So naturally, what do I do when I get my hands on a truck from the South? I plan to cut it up and lay it...- Steve E
- Thread
- 1983 air bagged bagged lowered short box conversion slammed
- Replies: 11
- Forum: Introduction
