c10

  1. 77Big10

    Does a seal exist for my factory 1977 c10 sliding window

    I just pulled this seal out of my 1977 C10 Silverado. I'm 95% certain it was the factory because it's so beat-up and had the matching aged chrome lock strip. I've been finding mixed answers on what is the best solution for this fix. I don't have a preference whether it has the Chrome locking...
  2. H

    SWAPPING 84 c10 body onto 84 k10 FRAME

    I’m buying a donor vehicle to swap the body onto my k10 frame … 84 c10 to 84 k10. my question is how will the hump in the cab be and what can I do to modify this without placing a body lift on the truck and everything else should bolt up I’m pretty sure. Could I also use the 2wd crossmembers...
  3. EricLeny

    New Member, Buffalo NY

    Hi all, For your viewing: a 1986 C10 Silverado Long Bed Regular Cab, with 305 small block and automatic transmission. In good condition, with apparently 118k miles on the original motor. Originally a farm truck from Arkansas, restored (paint, dash cover, & minor mechanical) and garaged in the...
  4. T

    Not using factory fuse box after engine swap, lighting wiring with column and ignition switch problems.

    I have 84' C10 that is pretty much completely gutted inside and out, it has a Ls and 4l80e in it. Before this month it was wired awfully from the swap with a rat nest of unused wires hanging around under the dash. since its engine swapped and only has exterior lights, no blower radio dome light...
  5. TotalyHucked

    Help me decide, paint the camper shell light blue or dark blue

    Ok guys, I need your help. Picked up this camper shell last week and cannot for the life of me decide which of my 2-tone colors to paint it. It's currently black. I did these completely professional photoshops :rofl: to see how it'd look in both colors. I like it both ways. I'm leaning...
    • TotalyHucked
    • Thread
    • blazer c10 camper shell cap color paint topper
    • Replies: 61
    • Forum: Exterior
  6. Bo69

    83 C10 Vacuum System [HELP]

    I inherited this truck with the vaccum hoses all over the place, some off, some seemed to have disappeared, maybe some stuff has been deleted? I did my best to try to figure out where the remaining hoses went and capped off the rest of the ports. How did I do? Can some of this stuff just be...
  7. Goulet264

    Brake light opens when in R

    Hi, I just bought a 1981 chev very recently and I avoid driving it because of a slight issue. When I put it in reverse, 2nd or 1st gear, the brake light on the dash lights up for a second. I'd rather be safe than sorry, does anyone know what the issue could be?
  8. M

    1979 k10 clutch sticks and only works half way

    So I just did an Ls swap on a 1979 k10 stepside. I put a 2005 5.3 with the original transmission which is a sm465. I had trouble with this before the motor swap but now I’m going to address it. You can push my clutch pedal halfway down before the clutch engages. And when you to lift your foot it...
  9. A

    POST your 73-80 paint jobs

    Hello guys, I got a '78 C10 long bed and I've been looking for a cool 70s-80s style paint jobs or paint schemes. I'd like to see some of yours.
  10. M

    Looking for a orange driver side fender

    Here’s my 76 C10 I picked up awhile ago. Im looking for a original paint orange driver fender. They rest of the paint is nice solid patina but the driver fender has a little too much for my liking. Please let me know if you have one you’re willing to sell thanks !
    • myles marks
    • Thread
    • c10 fender scottsdale short bed
    • Replies: 1
    • Forum: Wanted
  11. squaredeal91

    Gave away my LS

    I thought the title might grab attention lol, and this is my first thread. Anyways A couple years ago I parted out a Yukon with a 5.3 and planned to use it in my car. The more I thought about the more I decided I love the small block too much to go that direction. My mom still has the 69 c10...
  12. L

    C10 1985 305 stalled and now won't start and choke won't come on

    I need help to start my truck again,I was driving with my brother to the park but once I started going up hill it started to sputter like if it wasn't getting any gas then it died. I walked to get my other truck so I could pull it and when I got back I tried to start it but only stayed on for a...
    • Luisd02
    • Thread
    • 305 1985 longbox 2wd c10 carburetor choke light gas wont start
    • Replies: 1
    • Forum: Tech Discussion
  13. bigAL

    Hello from CA!

    Hey y'all, I've finally been able to get my hands on a C10 and I couldn't be any happier. This thing is so badass. I have a 1974 C10 with a 400 small block. I want to make it clear that I'm no mechanic whatsoever, but I'm capable of learning. The previous owner painted the truck black, but I...
    • bigAL
    • Thread
    • 1974 400 c10 cheyenne dark spot polishing rims
    • Replies: 12
    • Forum: Introduction
  14. theunderlord

    What to Buy?

    hey gang, long time lurker, first time poster, My plan is to build a lowered, LS swapped, single Turbo'd 800-1000HP, LWB 2 door square body. I've been looking for the perfect rust free truck to get started, but of course its a needle in a haystack to find a relatively rust free C10. The...
  15. Tubby Tubbs

    My truck had a bonfire inside the cab last night

    So long story short, last night something in my jacket pocket decided to spontaneously combust and Burnt up the the inside of my truck. Luckily really only the bench is damaged but not sure what to do? Are the whole benches actually only 250? how much do y'all think it would cost for...
    • Tubby Tubbs
    • Thread
    • c10 damage fire georgia need help seat
    • Replies: 48
    • Forum: Interior
  16. Tubby Tubbs

    Free power mods on 305?

    Does anyone know how to squeeze any extra power out of the 305 in my c10? Like is there something I can adjust with the air intake or something that'd make a difference? Also I'm not necessarily looking for any huge improvements (I mean power costs money lol) but like even 5 more hp would be enough
  17. AyWoSch Motors

    73-75 C10 mirror.

    73-75ish Chevy/GMC C10 sport mirror. In great shape, chrome is nice, glass is perfect. Just the one, can be either drivers or passengers just by rotating the housing. I have no use for it, figured someone might need it. Want it to go to use instead of it sitting in a bucket and risk breaking...
  18. OchoCinco

    '85 C10 From Houston

    Pretty nice forum here! Just got my 1985 C10 a few months ago, trying to fix some things the previous owner didn't get a chance to fix/improve. She has a 350 5.7 Vortec from Gordon's Engines (anyone hear good things about them?). I'm no mechanic but looks like PO let was slacking on engine...
  19. MikecLA

    Under hood, what was here?

    Wasn’t sure where to post this one , I scored some windshield washer nozzles at the junkyard and putting them on my 74 c10 hood I see this giant hole, was this for a factory under hood light perhaps? Aftermarket hood most likely so maybe a universal hole? Thanks
  20. Juan Cano

    New 1986 C10 Silverado 305 (or maybe 350?)

    Hello! I just got this truck and I think I overpaid. My first truck, got too excited... anyway. Truck body is in good shape, paint pretty good. Frame and all that in good shape. Guy sold it is a mechanic. Transmission has been rebuilt. Engine runs well, idle wells. Only 99,900 miles. Looks like...
  21. MikecLA

    Proper high beam switch mounting

    Just put in a full carpet in my 74 c10 and wondering how the floor mounted highbeam switch it’s is supposed to be mounted, under the carpet or over the carpet. The utilitarian in me says the truck just had the switch mounted on top of the carpet with the two screws going down through it...
    • MikecLA
    • Thread
    • 1974 c10 carpet high beam switch
    • Replies: 6
    • Forum: Interior
  22. C

    transmission engine options

    I have an 1984 c10 3-speed column shift. Im looking to do an engine swap, but I want to keep the 3-speed. I currently have a 250cu l6. What engines would mate with my tranny? Thanks for the help!
  23. K5ride

    52" VS 56" Rear Leaf Springs

    I have a 75 C10 Stepside and I'm changing the rear leaf springs. When I went online and purchased them from SD Springs, they only listed the 52" with a 4 leaf spring pack like I currently have. I "assumed" mine were 52" as all of the 56" had many more leafs. Okay, I admit I'm an idiot for not...
    • K5ride
    • Thread
    • 52" 56" c10 leaf spring hangers leaf springs stepside suspension
    • Replies: 3
    • Forum: Tech Discussion
  24. Owen Pollock

    Engine swap From 250 6 cylinder To 350 sbc

    Hey guys, so I will be rebuilding a 350 small bloc engine and replacing my current inline 6 motor with it. I am wondering what I will need for the 350, ex. Engine mounts, new rad, new trans (I believe mines a turbo 350) or just anything important that i will need before the swap. Thanks !
  25. M

    Belltech 4/6 Lowering kit with air bags for towing

    Hey guys, I have an 85 c10 short step-side and am doing a 6'' drop, axle flip with belltechs c-notch. I want to be able to tow with my truck still. Has anyone here fabricated anything or know of a kit to run air bags with this set up? Thanks!

Latest posts

Forum statistics

Threads
44,411
Posts
956,913
Members
36,729
Latest member
Massimo
Top