350 sdc
-
Q jet bolts question
I know this is kind of a stupid question but. What size are the 80’s q jet bolts that attach it to the intake? Should I go to a local hardware store and get them or spend the 50$ to ship ARP bolts to Canada thru summit.- Old man Lucas
- Thread
- 350 sdc quadrajet
- Replies: 1
- Forum: Carb Fuel Systems
-
6.2 Detroit into a 84 gasser
Scored an 1986 J code 6.2 Detroit Diesel no ac Engine for the future power plant for my 1984 gmc k25. New Donor power plant has 180k mileage so not that to bad. My plan for the swap was to tear down to the block, inspect the heads, slap it back together with new gaskets/seals. Most likely get...- Highsierra84
- Thread
- 350 sdc 6.2 detroit 6.2l diesel chevy diesel swap engine swap gas to diesel gmc hydroboost wiring harness
- Replies: 4
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
Engine swap From 250 6 cylinder To 350 sbc
Hey guys, so I will be rebuilding a 350 small bloc engine and replacing my current inline 6 motor with it. I am wondering what I will need for the 350, ex. Engine mounts, new rad, new trans (I believe mines a turbo 350) or just anything important that i will need before the swap. Thanks !- Owen Pollock
- Thread
- 350 sdc c10 engine swap inline 6 short bed
- Replies: 42
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
Piston rod cap torque sequence
First I have to say I'm a cabinet builder building a motor for the first time. So tolerances are quite different. I'm building a 4bolt main chevy 350. I just put the pistons in and want to torque down the caps. There has to be a sequence to tightening down the caps. I tried starting with #1...- Jt1776
- Thread
- 350 sdc rods and caps torque
- Replies: 17
- Forum: Tech Discussion
