Search results
-
T
Not using factory fuse box after engine swap, lighting wiring with column and ignition switch problems.
Didn't see the screenshot must not have loaded or something, but i pulled the wiring out of the frame and holy smokes previous owner had a hayday with duck take and solder. so I've taken it upon myself to replace every wire, no sense in replacing 10 ft of a 15 foot circuit, most of the wiring is...- Trenholm
- Post #5
- Forum: Electrical & Audio
-
T
Not using factory fuse box after engine swap, lighting wiring with column and ignition switch problems.
I gave up on googling answers and just put my multi meter to work, basically came to the conclusion GM is smart but also not obvious about where wires go, i attached a picture with a wiring scheme i drew up quick. I'm aware of what wires i need on the ignition switch it was only the wiring going...- Trenholm
- Post #3
- Forum: Electrical & Audio
-
T
Not using factory fuse box after engine swap, lighting wiring with column and ignition switch problems.
I have 84' C10 that is pretty much completely gutted inside and out, it has a Ls and 4l80e in it. Before this month it was wired awfully from the swap with a rat nest of unused wires hanging around under the dash. since its engine swapped and only has exterior lights, no blower radio dome light...- Trenholm
- Thread
- 1984 c10 engineswap lighting turnsignal wiring wiring
- Replies: 5
- Forum: Electrical & Audio
