Search results
-
need oil fill tube gasket
Does anyone know where I could find the thick gasket on the base of an oil fill tube? This one is hard as a rock and doesn't seal well.- fast 99
- Thread
- Replies: 0
- Forum: Engine & Performance
-
actuator rod
Does anyone know where to get an ignition switch actuator rod for a 78 tilt column that is reasonably priced? I found one outfit that has them but $175 is a rip off.- fast 99
- Thread
- Replies: 7
- Forum: Tech Discussion
-
A pillar gauge pod
Has anyone been able to find A pillar trim [drivers side square body] that has a provision for a single gauge? I know there is a universal piece available. Trying to find a direct fit. Picture gives you an idea of what I am looking for. -
81 up dash pad anyone bought one recently
Been waiting since September for a dash pad for an 81 from USA1. Sent a couple e mails in the last few days. They still don't have any expected delivery date, none at all. A recent post said the LMC was good quality on the 73 up style. Before I cancel the USA1 order has anyone purchased a... -
emblems for less
FYI, this outfit came up on a search. Ordered a set of fender emblems. They are about 1/2 what everybody else wanted. Says they are OER so should be decent quality. $70 a pair. https://classicbodyparts.com/product/1981-88-chevrolet-truck-scottsdale-30-front-fender-emblem-pair/ -
95 N N Code big block swap question
Have a friend who wants to install a big block in a 78 K10. Wondering if a N code 1995 big block swap will work? Wants to use the older brackets, pulleys and manifolds from an 80's truck making it appear stock for the era. Am thinking it will work but need an aftermarket carb intake to fit the...- fast 99
- Thread
- Replies: 3
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
SB jump
From another site, don't know if they stuck the landing.- fast 99
- Thread
- Replies: 3
- Forum: Off-Roading
-
jack parts
Got lucky this morning. Found most of the jack parts except the lug wrench. Been looking for this stuff for years it's always gone. Cost $10 -
interior parts recommendations?
Getting close to ordering parts for a 2 door 85 Scottsdale red interior. There are lots of vendors. Who seems to have the best service and quality? List below. Thanks Door panels Dash pad Floor and lower door carpet Bench seat upholstery Chrome front bumper Seat belts Weather striping -
can seat belts be re-dyed?
Asking if anybody has had success re-dying seat belts? Talked to Jacquard dye company, they said it can be done with their acid dye. The ones in the truck are faded. I know there are new ones available but mine are the dual retractor type and would like to retain them if at all possible. -
new here
New here, in the process of restoring an 81 K20. It has been in the family since new. Millage is unknown but probably in excess of 300k. Has had nearly every body panel replaced except the cab and hood and only has very light surface rust. Interior is junk from sitting since 2008. Going back to...- fast 99
- Thread
- Replies: 9
- Forum: Introduction
