Search results

  1. Georgeb

    New Guy

    Welcome
  2. Georgeb

    Blinker Indicator Issue

    Ok, check that your parking brake pedel is returned fully. You can aslo Unplug the wire from the proportioning valve in the braking system. It is located on the cross member below and behind the radiator. Report back if the light goes out. If it does not trace the wires looking for a short to...
  3. Georgeb

    Blinker Indicator Issue

    the warning lamp in the cluster?
  4. Georgeb

    Blinker Indicator Issue

    Check for power on the light blue wire in the plug for the cluster when you have the left signal on. If there is no power present "pulsing on and off with the flasher" your problem is in the wiring leading up to the cluster. If power is present it is an issue with the cluster. Also be sure that...
  5. Georgeb

    Blinker Indicator Issue

    What have you tried? Have you veified the light, socket and signal to the cluster.
  6. Georgeb

    turn signal issue

    I don't think that will change anything. You are going to need to set aside a chunk of time and systematically check each item Chengny outlined earlier. You have a short between the right and left signal wires somewhere and you need to trace them from the turn signal switch to the front lamps...
  7. Georgeb

    turn signal issue

    They will only aternate when the running or headlights are on. Otherwise they flash at the same time as the fronts.
  8. Georgeb

    Bvllsh!t on craigslist.

    https://chicago.craigslist.org/sox/pts/6041724190.html
  9. Georgeb

    turn signal issue

    The rear lights use different contacts in the turn signal switch so technically yes.
  10. Georgeb

    turn signal issue

    At this point I would disconnect the turn signal switch and check to see if you get continuity on the two wires mentioned When you are supposed to. This will determine if the signal switch is good or bad. Then move down the line to the next connector.
  11. Georgeb

    turn signal issue

    Old77 this needs a sticky!
  12. Georgeb

    Shifting question

    It can be. Try pulling it in while you are still rolling to the stop.
  13. Georgeb

    Shifting question

    The SM465 is a slower shifting transmission. About all you can donto improve it is make sure the clutch is bled properly and consider going to GL-4 rated gear lube if you can find it. Those a big heavy gears in that trans and it takes time to slow them down between gears. Upshifts will be much...
  14. Georgeb

    Bvllsh!t on craigslist.

    https://chicago.craigslist.org/chc/cto/6039846275.html
  15. Georgeb

    Surging problem and cause

    The way I understood the trottle plate setting was to read tps volts and set the throttle plates accordingly. You will want to be reading 4.5 volts with the plates closed. Adjust that with the engine not running. Open and let the throttle snap closed a few time rechecking the voltage each time...
  16. Georgeb

    Brake problem

    I'm with this guy.
  17. Georgeb

    350 Turns over but does not start

    According to the OP there are wiring issues but those are easily fixed via solder and shrink tube as well.
  18. Georgeb

    No Grease Fittings???

    I have also run into factory joints with no provision to grease them that have run an incredibly long time. For instance the wifes Envoy had arounf 190,000 on the originals on the drive shaft.
  19. Georgeb

    late model column question

    That would be my guess as well.
  20. Georgeb

    Anyone ever used square tubing for a bull bar?

    Do you have any pics of what you want to accomplish. IMWO if you use 2"x.125" AW square tube it will reasonably take whatever you throw at it within reason. If done right square tube would go well with the square truck. You could also be on the lookout for other bull bars that could be used as...
  21. Georgeb

    late model column question

    Here ya go! http://www.gmsquarebody.com/forum/showthread.php?t=5870
  22. Georgeb

    How Come You Never See This Anymore?

    Please stop... :drool::hump::drool::hump::drool::hump::drool:
  23. Georgeb

    How Come You Never See This Anymore?

    I think that looks awesome!
  24. Georgeb

    350 Turns over but does not start

    1. Do you have spark? 2. Have you checked the timing while cranking to make sure you are not way off? I don't think I would be jumping to a new distributer without doing the simple checks first.
  25. Georgeb

    late model column question

    Is the switch gone or the lock cylinder or ????? Got a pic???? I wouldn't swap a column for either of those two parts.

Latest posts

Forum statistics

Threads
45,481
Posts
984,324
Members
38,534
Latest member
Jcarrasco314
Top