Search results

  1. Broken85

    High Pressure Fuel pump install

    Also found this little gem on LMC’s website. I haven’t seen something like this for sale anywhere else. https://www.lmctruck.com/fuel-system/fuel-pumps/fuel-pump-control-module-15 Still no motor in the truck yet, but I will be sure to follow up when I get this done and running!
  2. Broken85

    High Pressure Fuel pump install

    Man, this looks like the way to go. I am already committed to this inline set up, but I might mortgage the house and put two of these in the shelf!
  3. Broken85

    Steering Column needs to be rebuild

    If you have enough skill to get the whole column out today the truck I think you can do the build yourself. All you need is a big table and a lot of patience. I tried to do mine while it was still in the truck and regretted it immediately. If it has all the bells and whistles (tilt, intermittent...
  4. Broken85

    High Pressure Fuel pump install

    Finally updating the powertrain on my 85 K10 Silverado short bed with a BluePrint turn-key, fuel injected 350. I am going to have to upgrade to a high pressure fuel pump obviously but I wanted to check with the group first before I install this. My issue is that I have dual fuel tanks so I...
  5. Broken85

    Please Help I'm Stuck!

    Check under dash and see look for this connector. It will be somewhere around the base of the column, but you won’t need to pull much apart. I don’t think your AC duct will be in the way either. It is a flat connector with two pins on each side. There is no other connector on the truck that fits...
  6. Broken85

    Intermittent steering wander?

    I had the same/similar issue. Blazer with a 6” lift. Guy before didn’t have it set up, and a 6” lift is way too high for such a short truck (my opinion). It kept loosening bolts on the steering box, and I expected eventually it was just going to crack the frame. I eventually figured out the...
  7. Broken85

    Best header back exhaust package for a 1985 K10 short bed

    Yeah, I hear ya. Definetly would be the easy button. I figure, if I am doing all the work of swapping a TBI motor into it by myself, I might as well keep the whole job DIY for bragging rights. That truck hasn’t been to a mechanic in over 25 years. Except for the paint, there is only one guy who...
  8. Broken85

    Best header back exhaust package for a 1985 K10 short bed

    Evening fellas! I am lining up my winter project and planning to swap the Jasper motor out of my shortbed for a Blue Print 340hp TBI turnkey. I am looking for recommendations on a header-back exhaust system with side vent pipes. Plenty of stuff out there for long beds, just not seeing what I...
  9. Broken85

    Wanting Led upgrade throughout while keeping stock look... Recommendations?

    I switched all four corners of my 85 over. I used the LMC after market fender lights, they work better than other options. One thing that you have to know since you are replacing your marker and brake/blinker bulb, know that all bulbs are not made the same. The problem that I found is that most...
  10. Broken85

    wiring issues

    Trying to think where a fuel gauge would cross with the headlights, and the only thing that comes to mind is the printed circuit behind the gauge cluster. Start there, any thing shorting should be fairly obvious. The previous owner may have added that rat nest to bypass an existing problem...
  11. Broken85

    Help finding a short, Who's good at ELECTRICAL???

    I know you said this truck is stock and unhacked, but what’s the story of this box?? Is that a snow plow relay or something? Looks like maybe something after market. Also, I assume this is a single battery set up, but if it’s not, are both batteries good?? One bad battery will ruin both of...
  12. Broken85

    Front bumper opinion on position

    That would drive me nuts. I think one of the bumper supports are out of wack. If you are going to go through the trouble of taking the bumper off to open up the holes on the bumper supports, just put a set of new bumper mounts on it in stead. I bet when you take the bumper off, the mounts are...
  13. Broken85

    Pass power window

    This kits come with an up and a down relay for each side (4). I wired that kit also. Mine came with a bad relay and the window was stuck up. If it is up and won’t go down, or vice versa, swap the relays and see if it works. They plug in and out of the harness so they are easy to replace.
  14. Broken85

    Dome light went cross-eyed.

    Well done! LMC does sell an LED upgrade cabin light, but if you go for it know, it is not plug and play. You are going to have to cut the roof to make it fit. Also, found out this weekend the dome light is on the fuse for the horn. The light under the dash is a separate circuit on the courtesy...
  15. Broken85

    No dash lights!!

    Pull the LEDs out and start with incandescent bulbs. LED bulbs do not operate on two separate circuits (one for marker and one for blinker). They operate on one circuit with high and low settings which means an LED bulbs will cross your marking and blinker circuits at the socket across the...
  16. Broken85

    Dash blinker lights glow when the marker lights are on.

  17. Broken85

    Dash blinker lights glow when the marker lights are on.

    I think you are onto it jgonick. In looking at some tech specs on LED bulbs, they do not operate with two separate circuits (a dim and a bright). They operate with on one circuit with two power modes (low and high) using the same LEDs so the markers are likely crossing with the blinker lights...
  18. Broken85

    Dash blinker lights glow when the marker lights are on.

  19. Broken85

    Dash blinker lights glow when the marker lights are on.

    So, let me start off by saying I did this to my self by installing a Vintage USA dash in my 1985 K10 Silverado shortbed during a full restoration. Mistake, nothing but problems. This is NOT a plug and play upgrade. Expect to spend countless hours with whatever wiring diagram you can find on...
  20. Broken85

    How would you make this truck less ugly??

    Option A- win the lottery Option B- add more rust to it and put a 600 hours 454 under the hood. It will be a panty dropper. Don’t kid yourself into thinking you can touching one bolt on that body without without it turning into a disaster. All you are going to do is snap heads or strip...
  21. Broken85

    Factory 3 point seat belt harness.

    If you reupholstered the interior, don’t be a victim of the “plush monster”. There is a pendulum it the seatbelt ratchet system that needs to move freely. When inertia moves it forward, it locks up the ratchet for safety. New carpet will also encroach on the weak plastic casing and bind the...
  22. Broken85

    Trailer Wiring Adapter

    I started with the adapter bought but bought this guy, ran an extra hot, and a break wire, tapped the reverse lights and updated the whole truck to a 7/4/5 pin. https://a.co/d/dgRajjx
  23. Broken85

    Problematic Starting - rotate crank before starter engages?

    Check your timing. If it is to far out the starter will bind and not turn over. It will actually lock up the motor until you spin it by hand to let the starter work. Makes the starter sound like a train wreck too
  24. Broken85

    1985 K5 keeps breaking starters, help!

    Definetly check the timing, sounds like a to advanced problem. Also make sure you are using a timing chain cover with the correct markings on it. If your motor is a Frankenstein, you may be looking at the wrong timing chain cover, or looking at the wrong balancer especially if you used parts...
View older results

Latest posts

Forum statistics

Threads
45,453
Posts
983,771
Members
38,501
Latest member
thatgermanguy
Top