Search results

  1. B

    "Overheating" --> Now Fuel Delivery Issue --> Dirty Tank?

    I think I have it fixed. All this was used by a 3 inch peice of hose. Which was 7 years old. Ran the truck for a while with no problems. Thanks for all your help and suggestions
  2. B

    "Overheating" --> Now Fuel Delivery Issue --> Dirty Tank?

    This sounds simpler than dropping and switching tanks. May also swap left and right inputs to the switching valve to make sure that is not the problem.
  3. B

    "Overheating" --> Now Fuel Delivery Issue --> Dirty Tank?

    I've got a '87 and up baffled tank waiting for the LS swap. Am I correct that the mechanical pump sending unit will fit in the newer baffled tanks?
  4. B

    "Overheating" --> Now Fuel Delivery Issue --> Dirty Tank?

    Added a temp sensor and hooked it up to the dash gauge. Started the truck up and ran it in the driveway for a while. The gauge rose to about 210 and stayed right about there. Didn't want to risk running and getting stuck. When running on the driver's tank, the fuel in the filter is really...
  5. B

    "Overheating" --> Now Fuel Delivery Issue --> Dirty Tank?

    Just checked - two line pump
  6. B

    "Overheating" --> Now Fuel Delivery Issue --> Dirty Tank?

    I didn't look yet, but it's the mechanical pump. I thought they were all two ports : one in and one out
  7. B

    "Overheating" --> Now Fuel Delivery Issue --> Dirty Tank?

    Thanks all! This got a much bigger response than I expected. I'm running a mechanical fuel pump from a dual tank system. with a recent oil change after the problem started, the oil did not smell like gas I have a fuel pressure regulator set to 3 or 4 psi - I'll bump it up a bit and see what...
  8. B

    "Overheating" --> Now Fuel Delivery Issue --> Dirty Tank?

    New or worsening problem with my '84 K10 (350 SBC) that I would describe as overheating, but I don't think that it is: After 20 minutes of local around town cruising or shortly after getting off the highway and hitting the local roads, the truck sputters, dies and won't restart. The glass fuel...
  9. B

    Electric Fan Runs After Shutting Off Engine: Where To Start

    Thanks All - this will have to wait to the weekend to troubleshoot. Let the truck sit overnight and replaced the fuses and all was fine. Haven't had the chance to run it and see what happens.
  10. B

    Electric Fan Runs After Shutting Off Engine: Where To Start

    Truck sat for a while - I only used it sporadically over the winter, but would start, run and stop with no problems. Today, I took it for a longer highway drive and when a got to work, the fans kept running, which they normally do not do even when the engine is hot. Pulled the fuses, did what...
  11. B

    Flashers Do Not Always Flash

    @SirRobyn0 That generally was what I thought. Today was much cooler and the flashers worked on the 45 minute drive to work. I am going to skip the test and just get a flasher that is good with LED bulbs, because eventually I want to switch all the "little" bulbs out to LED
  12. B

    Dome Light Comes on with Headlights

    I suspect that the answer will be "check your grounds." I'm not looking forward to that. Dome light works as it should - open the door and the light comes on (original switches stick a bit, but his the button once or twice and on they come.) I just noticed that when I turn one the headlights...
  13. B

    Flashers Do Not Always Flash

    My flashers don't always flash. When I first got the truck, they worked fine, but over time they got more problematic. More likely than not, they will flash at the begining of the first trip of the day and then at some point, the turn signal lights will light, but not flash. I don't know if...
  14. B

    Driver side window removal.

    Swear words and the uncomfortable feeling that you may drop the window at any time. I have power windows, but I think the procedure is roughly the same. Roll the window down and remove the rear track from inside the door and the felt trim all around. I removed the wing window - this might not...
  15. B

    How to achieve tighter steering?

    I am going to Borgeson route - its not quite $300. Its cheaper (I think) and less work than crossover steering. The Jeep intermediate shaft is probably cheaper but I don't have a pick and pull or any good yards near me. Check out this video for the shaft and steering bearing replacement:
  16. B

    What have you done to your square lately??

    This took a week, but I mostly finished today: New interior except for the dash. Hit a snag last week when i could not get one of the seat bolts back in. Fought with it for an hour and said screw it. Today the seat came out, again, and I pretty much just put it back in and it lined up...
  17. B

    Can't Get Driver's Inner Fender Back In

    Also, I'm not sure how securely attached the inner fender is to the outer - there might be a lot of flopping around as you try to maneuver the unit.
  18. B

    Compressor overload keeps tripping

    Fixed: Repair shop replaced a faulty overload switch. Technically a DIY job but I would not have been able to identify it except by just throwing parts at it. Plus it would have required disassembling the motor and I didn't trust my ability to get it back together
  19. B

    What new tools have you got lately?

    I thought this was a joke when I first saw it
  20. B

    Compressor overload keeps tripping

    All replies seem to be pointing to a bad motor. I'll have to contact the repair shop and see what my options are
  21. B

    Compressor overload keeps tripping

    The motor turns pretty easily by hand. And smoothly too. I doubt it's a bad beating because there's no bearing squeal and generally the motor is quiet
  22. B

    Compressor overload keeps tripping

    "Pereira" relief valve = pressure relief valve, that's some autocorrect madness. So, I called a local electric motor repair shop to see about testing the capacitors (I don't have a proper multimeter for that) and he said that it wouldn't be them and to check the amperage to the motor. I didn't...
  23. B

    Windshield Wiper Fuse Location

    @SirRobyn0 - I started noticing that. The couple of places that had one listed showed them backordered or with no availability. I'm a German car guy and one thing I love about them is I can go to the dealer and get a 40 year old part (Drip rail trim from a 1969 BMW 1602 - one week to the...
  24. B

    Windshield Wiper Fuse Location

    So today I had time and broke out the multimeter and the manual. Turns out I have high but not low speed, and the diagnosis flow chart says that it is a pump issue - most likely dislodged low speed brushes. Recommendation is to replace/repair the pump. I'm going to be looking for an AC Delco...
  25. B

    Windshield Wiper Fuse Location

    @SirRobyn0 thanks. Fuse was good time to check grounds and power this weekend

Latest posts

Forum statistics

Threads
44,426
Posts
957,666
Members
36,791
Latest member
bperez3
Top