Search results

  1. SASKCHEYENNE75

    Stalling Issue

    Good point I will try that
  2. SASKCHEYENNE75

    Stalling Issue

    What is that?
  3. SASKCHEYENNE75

    Stalling Issue

    Another thought. Could it be a vacuum advance issue? The distributor I put into it is am Accel 59130 It had a vacuum advance stop plate in the packaging which I didn't install. Should I have?? I haven't dialed in the timing yet either. The vacuum advance is hooked to the vacuum port on the...
  4. SASKCHEYENNE75

    Stalling Issue

    The little filters in the Holley carb were replaced with the rebuild. I also have an inline WIX fuel filter between the mechanical fuel pump and the carb. It has fresh gas in it and the filter looks clean. I used to have an 82 Chev C10 that had working AC.when I'd run the AC it seemed to act...
  5. SASKCHEYENNE75

    Stalling Issue

    1986 Chev K30 Crew Cab 350 with Holley Carb The truck sat for a number of years so I've been slowly working my way through it. I got it to run and idle but was running rough so I pulled the carb (Holley) and got it rebuilt. I also swapped in a new distributor. The truck starts and idles good...
  6. SASKCHEYENNE75

    Transmission Identification

    Thanks everyone!
  7. SASKCHEYENNE75

    Transmission Identification

    Id Tag
  8. SASKCHEYENNE75

    Transmission Identification

    I picked up a scrap truck for a few parts and this transmission was in the back. Can someone help me by telling me what it is? I'm thinking a th350 but I'm not positive.
  9. SASKCHEYENNE75

    Help with GM 14 Bolt Rear End

    Great thank you
  10. SASKCHEYENNE75

    Help with GM 14 Bolt Rear End

    Thank you...what the heck would cause that to break like that?
  11. SASKCHEYENNE75

    Help with GM 14 Bolt Rear End

    Also I'm planning on using 80W90 gear oil is that correct??
  12. SASKCHEYENNE75

    Help with GM 14 Bolt Rear End

    I am in the process of changing the gear oil in my truck. 1986 Chev K30 Crew Cab 14 Bolt Full Float Rear End When I took the cover off to drain the oil it was quite dirty. There was also a fair amount of metal shavings on the magnet in the base of the housing including a broken clip. I will...
  13. SASKCHEYENNE75

    Fusible Link?

    Yes I had no headlights, tail lights, gauges, dash lights
  14. SASKCHEYENNE75

    Fusible Link?

    Yep the headlight switch was the first thing I checked and its operating as it should. As it turns out it was my fusible link near the starter. Replaced that and I'm back in business!
  15. SASKCHEYENNE75

    Well we bought another one...

    Just outside Moose Jaw.....right place right time I guess
  16. SASKCHEYENNE75

    Caliper rattles...help?

    Thank you I'll try that
  17. SASKCHEYENNE75

    Caliper rattles...help?

    Hello, Continuing work on my 86 Chev k30 Crew Cab. Got it running (sort of lol) and took it around the block. Ran and shifted fine but had a horrible metal on metal knock which went away when brakes applied. Took off the front wheels and my passenger side caliper was loose and knocking on the...
  18. SASKCHEYENNE75

    Fusible Link?

    Thank you!
  19. SASKCHEYENNE75

    Fusible Link?

    Now I'm left with these two wires that go to the starter along with the big battery cable. I'll replace the end of the smaller wire too likely. Does that need a fusible link too? So both of these wires need a fusible link?
  20. SASKCHEYENNE75

    Fusible Link?

    1986 Chev K30
  21. SASKCHEYENNE75

    Fusible Link?

    Good afternoon, I have no power to my headlight switch. I removed the switch and tested the contacts to make sure the switch is working properly and it is. Next I checked for constant 12v power at the red wire in the headlight switch harness and there is none. I disconnected the 3 wires from my...
  22. SASKCHEYENNE75

    In your opinion?

    Going through my recently purchased truck. I plan on getting the carb rebuilt as the truck sat for a number of years. Before I do tho I just want your opinion on whether it's a good carb for the setup? Truck: 1986 Chev K30 Crew Cab Originally a 6.2 Diesel swapped with a SBC 350 4 bolt main...
  23. SASKCHEYENNE75

    Another Question!!

    Thank you....yes I absolutely am getting a steel fuel line. Its on the to-do list!!
  24. SASKCHEYENNE75

    Another Question!!

    I think it was the two red wires that go to the post throwing me off. I thought an internally regulated alternator only had 1 red wire to the post
  25. SASKCHEYENNE75

    Another Question!!

    Thank you!

Latest posts

Forum statistics

Threads
44,173
Posts
950,857
Members
36,288
Latest member
brentjo
Top