Search results

  1. 75k20

    Sm465 clutch fork has massive amount of play

    i should be able to just get replacements and replace them one at a time right?
  2. 75k20

    Sm465 clutch fork has massive amount of play

    here’s what the cab mounts look like. i’m not sure why there’s metal cutouts stacked on top of the front cab mounts. any ideas?
  3. 75k20

    Sm465 clutch fork has massive amount of play

    yeah that’s makes sense, and i’ve been driving the truck everyday to work, it’s my dd. i have the pedal setup to start to disengage the clutch about 1” of down travel in the pedal. this morning i pulled the carpet back and could stop the rattling noise by putting my finger between the rod and...
  4. 75k20

    Sm465 clutch fork has massive amount of play

    yes by adjusting the rod i can no longer shake the clutch ford by hand, im thinking of pulling off the rubber boot and sticking a camera in to see what the mess is. the transmission has paperwork for a rebuild transmission about a year ago, but that was before i owned it and a lot can happen...
  5. 75k20

    Sm465 clutch fork has massive amount of play

    the rattle seems to come from the clutch rod going through the floor board. if i push the clutch pedal in slightly about an inch, the chatter goes away and so does the headache.. would replacing the pivot point bushings help this? or does there seem to be internal damage as well
  6. 75k20

    Sm465 clutch fork has massive amount of play

    i got a 75 k20 with a 350/465/205 set up the clutch rattles like an AK while you’re driving down the road. anything from idle to cruising. i checked out the adjustment rod that goes into the clutch fork and i could literally pull it out of the socket with my hands.. i don’t know how it was...
  7. 75k20

    help quick! sm465 crossmemeber bolts

    took a peak under my truck and noticed there aren’t any bolts that hood the rear of the sm465 to the crossmember. can anyone tell me the size? i’m headed to the hardware store to hopefully find something to use. i believe theyre 1/2 coarse or 7/16 coarse
  8. 75k20

    missing axle shaft on dana 44 front. what do i need?

    here are some pictures of the front axle
  9. 75k20

    missing axle shaft on dana 44 front. what do i need?

    what’s the difference?
  10. 75k20

    missing axle shaft on dana 44 front. what do i need?

    my 75 k20 with the dana 44 front is missing the inner and outer axle shafts on the passenger side and i domt know what parts to order. i can hear the bearings starting to make noise since they’re been dry so long. the axle is full of fluid somehow but it has a lot of metallic flakes. what are...
  11. 75k20

    swapping gear ratio in the 14 bolt??

    i measured out the gears and it turned out to be 4.10s instead of 4.56s can’t complain but still not the best for a daily driver. 350/465/205/4.10 33” should be a decent enough setup for now. thanks for the responses
  12. 75k20

    swapping gear ratio in the 14 bolt??

    would something like 3.73s be suitable? that would put me at 55mph and 2000rpm
  13. 75k20

    swapping gear ratio in the 14 bolt??

    is there a good company that i should go with? i’m not looking to gain more speed, fastest i’d want to go would probably be 55 or 60, feels like i’m pushing the truck just to get up to 50
  14. 75k20

    swapping gear ratio in the 14 bolt??

    33x12.50 tires 17 wheels it’s next up on the long list of fixing stuff, but i don’t know if there’s any difference between the dana 44 axle shafts, or what seals i need.
  15. 75k20

    swapping gear ratio in the 14 bolt??

    i’ve been daily driving with the sm465 and 4.56 gears for a while now and i need something more suitable for everyday use. my mileage came back at 8.3mpg and i need to get my rpms a little lower while cruising. not to mention how slow i am speeding up.. right now i don’t use 4wd as it’s missing...
  16. 75k20

    can anyone tell me what has been done to this suspension?!?

    this is how the truck sits now on 33x12.50 tires
  17. 75k20

    can anyone tell me what has been done to this suspension?!?

    sounds good, do you think a 4” lift shock would be good all around? is there anything else you’d recommend?
  18. 75k20

    can anyone tell me what has been done to this suspension?!?

    does the front look like factory suspension? i think there are a couple small plates under the springs but i can’t tell for sure
  19. 75k20

    can anyone tell me what has been done to this suspension?!?

    i got some stock replacement shocks from an auto parts store and even fully extended they didn’t have enough reach in the back to be installed. so i could only assume that they would’ve been bottomed out 24/7. the front shocks seemed to bolt in okay. i’ll post some pictures of the front and...
  20. 75k20

    door lock cylinder not working on passenger side

    i should also note that i’m unable to push the lock down from inside the cab when the key isn’t inside the door cylinder, without the cylinder in the door, the lock moves freely up and down
  21. 75k20

    door lock cylinder not working on passenger side

    i have replaced the door lock cylinder with 2 different kits and both times the passenger side door will only turn 90 degrees to the left to lock it, but i’m unable to pull the key out in this position so i have to unlock it again in order to remove the key. any ideas as of how to fix this?
  22. 75k20

    tail light wiring mess, help!

    what do you mean pink wire? my fuel gauge has never worked as long as i’ve had it. am i missing one green and the pink?
  23. 75k20

    tail light wiring mess, help!

    got a donor bed for my 75 k20 from a junkyard. trying to figure out the wiring for the taillights and the previous owner did a major hack job. i have 3 wires coming from the truck, ones yellow ones light green ones brown i thought there were supposed to be 4 wires from the truck. some of...
  24. 75k20

    dual tank fuel system operation questions

    would i be able to use an electric fuel pump to prime my carb after my truck has been sitting for a while? i purchased the small edelbrock 38gph electric fuel pump. i don’t think my pump is bad because there is no gas in the oil from what i can tell. is there any benefit to using the return...
  25. 75k20

    trouble getting rear bed panel installed

    yes i got it from carparts.com and everything looked okay about where it was stamped. i’ll have to try it again some time. maybe i can use a bigger ratchet strap

Latest posts

Forum statistics

Threads
44,168
Posts
950,764
Members
36,283
Latest member
Cantrell299
Top