Search results

  1. curse

    Terrible gap

    After looking at it closer I think the top of the passenger fender was "rolled out" for lack of better words. I think the previous owner didn't realize it or didn't care and left it with that gap.
  2. curse

    Terrible gap

    I agree with grit dog, my truck has been molested. I'm finding a lot of things were done poorly. Thanks for the replies everyone
  3. curse

    Terrible gap

    I'm pretty sure they are the original fenders, I see areas of red that match the areas of red on the cab. I ended up putting a long (about 4 foot) level on the upper edge of both fenders and there is a big difference... the level actually rocks in the passenger fender and lays pretty flat on...
  4. curse

    Terrible gap

    Last one, driver side
  5. curse

    Terrible gap

    Here's some pics of the gap on passenger side between the hood and fender on my 79. I'm thinking the passenger fender has been bent out but wanted opinions from others so I'm not missing something. I was getting frustrated trying to make the gaps all over look a little better and noticed this. I...
  6. curse

    73 grille color

    I want to repaint my 73 grille. Is it all 1 shade of color or does it have darker ir lighter accents. I can't find a pic good enough to determine myself.
  7. curse

    steering column or shaft

    Can anyone hook me up with a steering column that has the double D end for the steering shaft (2 flat spots and center bolt) ...tilt or non-tilt...no headlight dimmer...and no wiper switch. Or a steering shaft with the splined end and rag joint end. My steering column and shaft were replaced...
  8. curse

    Headers not hot on 2 and 8

    So I switched #2 and #8 wires with each other and all header tubes were over 350 degrees and it ran really smooth until I took it for a ride. I think the ride possibly jostled a bad wire?? I think I'll replace plug wires
  9. curse

    Headers not hot on 2 and 8

    All new. Maybe I will swap wires and see if the condition follows the wires.
  10. curse

    Headers not hot on 2 and 8

    I don't think so but will double check today.
  11. curse

    Headers not hot on 2 and 8

    Low miles crate motor. I was told about 25000 miles. All I did was replace all gaskets.
  12. curse

    Headers not hot on 2 and 8

    What could be a cause of numbers 2 and 8 header pipes not getting hot. All other cylinders are getting over 300 degrees. 2 and 8 are only making it to around 114 degrees. Compression in all cylinders is 135-145 psi. When I put the timing light clip on the spark plug wires it flashes so I assume...
  13. curse

    Timing issues

    I didn't see that but went back and read it. That is goofy.
  14. curse

    Timing issues

    advance weights were stuck, I had to turn the rotor with a good amount of force to get the weights to move. Now they move but do not return on there own. This distributor has good reviews but it it says it will not fit my 79 c10 with a 350....why wouldn't it? Amazon.com: Performance Hei...
  15. curse

    Timing issues

    I have a gm crate motor in my 79 c10. When I set the timing and it runs nice and smooth it cranks over really slow and don't start, I figure too advanced (if I remember, at this setting it is at about 2 dbtdc). So I set it at 12 dbtdc and it turns over and starts easy but runs rough like the...
  16. curse

    no power to anything in cab

    I only have one question...does the bracket at the middle of the harness normally mount to the upper passenger trans to engine bolt?
  17. curse

    no power to anything in cab

    Got the new harness and installed it. Now everything seems to be operating like it should. I should have just replaced it a lot of headaches ago. Old versus new...
  18. curse

    no power to anything in cab

    I'm done, time for a new harness! Question...I have a nice interior harness out of a 78 and it has glass fuses. Any reason I shouldn't "go back" to glass fuses and order a 78 engine wiring harness?
  19. curse

    no power to anything in cab

    Am I correct in thinking the wires at the junction block should always be hot? I'm doing more wire tracing
  20. curse

    no power to anything in cab

    interesting. Another interesting thing is the wire that goes to the "s" terminal on the solenoid is also the power wire for my wipers! Lol.
  21. curse

    no power to anything in cab

    Thanks for all the thoughts and info. I wouldn't have guessed the fusible links that go to the starter solenoid would power the fuse block. Apparently the 2 fusible links that go to the solenoid are supposed to be twisted together and taped together because who needs any lights? I jumped the...
  22. curse

    no power to anything in cab

    Cool, thanks everyone. I'll check the other links.
  23. curse

    no power to anything in cab

    If I understood the 1979 diagrams I could figure my issue out.
  24. curse

    no power to anything in cab

    And what exactly is this....a block somewhere?
  25. curse

    no power to anything in cab

    I've been looking at the factory service manual and it's not the kind of diagrams i'm used to. What are the black circles next to 32BLK?

Latest posts

Forum statistics

Threads
44,166
Posts
950,714
Members
36,280
Latest member
rodfarm
Top