Search results

  1. plummrey

    Temp sensor disconnected

    I guess this explains something wrong, the connector is burned up,,(I see the brighter green wire connects to air compressor and they have the ground wire hanging, my ac-heat don’t work but that’s another day, but the two prong plug for that is a melted too) Does temp sensor need to be grounded...
  2. plummrey

    Temp sensor disconnected

    Thanks,, looks like mine is there from looking at my pics, but I’ve got a light green and green wire (I’m being lazy today instead of going out to actually look)
  3. plummrey

    Temp sensor disconnected

    Yeah sorry it’s not a better pic lol but I cropped it more, probably made it worse,,searching around seems to be the knock sensor
  4. plummrey

    Temp sensor disconnected

    Looking at my other pics I see where the green wire goes for the temp, I’ll have to look again but remember seeing the two green wires connected in the middle with a blob,, if gauge isn’t working may the sensor is bad
  5. plummrey

    Temp sensor disconnected

    Or is this the knock sensor, it’s in front of the starter. I was looking online to see about that plug and saw someone else’s post. If this is a knock sensor, does it need to be hooked back up, if so to where. I need to find the coolant sensor so it can be hooked up to my temp sensor on my...
  6. plummrey

    Temp sensor disconnected

    I was thinking something like that but wasn’t sure since nothings around it hanging at least right there
  7. plummrey

    Temp sensor disconnected

    Temp sensor looks to have been melted off and po wrapped it around frame, my gauge doesn’t work on dash guessing this is why,,, so where does the other end go and what kind of fitting/pigtail end would it have? Also the pic with the ? This thing was by the oil pressure sensor, it has a short L...
  8. plummrey

    How does this leak

    It needs the o-ring in the sleeve for the spline replaced,, so I took the u-joint off for nothing lol
  9. plummrey

    How does this leak

    Guessing the drive shaft needs to come off along with u joints, if so probably good time to replace those
  10. plummrey

    How does this leak

    Thanks!
  11. plummrey

    How does this leak

    Finally got the truck on ramps so I can get underneath and see my leaks. Since front end is up its really dripping at the transmission yoke, Does the ujoint need replacing or is it just a seal to replace? (a little at the speedometer gear housing & cable, looks like po did their own sealing...
  12. plummrey

    Another ? Won’t crank, stalls and gears won’t go in gear

    Left her on and tried shifting gears to see if I could feel them but same as my previous post, I put it in reverse just to see and gave some gas then it cut off. Since there’s an ac or heating on here I have the windows down so when I try crank and it makes the vroom sound it sounds like I can...
  13. plummrey

    Another ? Won’t crank, stalls and gears won’t go in gear

    She cranked up and gauge is this
  14. plummrey

    Another ? Won’t crank, stalls and gears won’t go in gear

    But it’s of course locked in the others, park and neutral still a no go , battery amps are around 12 on the gauge and goes down a little when trying to crank pics below, haven’t check battery with a multi meter yet
  15. plummrey

    Another ? Won’t crank, stalls and gears won’t go in gear

    Yes and the others too, even pushed up on park to make sure, will mess with it a little today
  16. plummrey

    What did you pay for a square

    Of course not a long Ed lol sorry my before and after pics are out of order
  17. plummrey

    What did you pay for a square

    1984 C10 long Ed my Christmas project present $2200, redid inside, found some good condition door panels and sprayed them with Herculiner, my Bondo dash same with a little silver glitter, put in vinyl flooring (have foot panels down so disregard my tape holding my wires in place), seat was good...
  18. plummrey

    Another ? Won’t crank, stalls and gears won’t go in gear

    It’s new but I’d have to check
  19. plummrey

    Another ? Won’t crank, stalls and gears won’t go in gear

    It was low and added some, just trying to figure out why it’s not even jump start, probably something stupid like the gas gauge looking more since I’m on a slight slant driveway Yeah had to pay for transmission work on one of my daughters truck in December
  20. plummrey

    Another ? Won’t crank, stalls and gears won’t go in gear

    1984 C10, it wouldn’t let me upload short videos of the sounds. Here’s a couple of problems which I have not messed with anything to screw anything up 1. Sometimes won’t crank or jump off, 3 different sounds, 1. Click 2. Vroom sound 3. Sounds like it wants to turn over but running out of juice...
  21. plummrey

    Gasket for this part

    I only felt it in the wheels, not in the steering or anything, I saw today that front left tire is bulging a little on the outside of the tread, I don’t drive this out yet except around the block but will wait til those are fixed
  22. plummrey

    Quad lights not working properly anymore

    Also forgot to resplice wires when changing the front marker light sockets, ( I had cut the wrong ones first) after fixing that the back small lights in the housing come on in the back . So can finally put my bezel and redone dashboard on
  23. plummrey

    Lights are all wonky

    Also forgot to resplice wires when changing the front marker light sockets, ( I had cut the wrong ones first) after fixing that the back small lights in the housing come on in the back . So can finally put my bezel and redone dashboard on
  24. plummrey

    Gasket for this part

    Thank you!
  25. plummrey

    Gasket for this part

    Just noticed this gasket is gone from this part, and can see it’s rub against the metal since it’s shiny, would this make a wobbly drive (felt wobbly when just driving around the neighborhood block like 20-25mph). Not sure the name of the part anyway

Latest posts

Forum statistics

Threads
44,166
Posts
950,718
Members
36,282
Latest member
Doug Hampton
Top