Search results

  1. custodian

    Cruise Control wire

    This is the end connector for the cruise control. After looking at it a little closer, I might be able to heat up the plastic cover and slide it back and just desolder and attach the wires to the old one and pull it through.
  2. custodian

    Cruise Control wire

    I will, be tomorrow. The first pick shows the side. I have it wrapped around the multi function lever for now.
  3. custodian

    Cruise Control wire

    The old wire is still there, was broke at the switch. Looks to run down the bottom of the steering column. I don't believe the end connector will pass through. Was thinking of cutting the end connector off, that connects under the dash, connect it to the old wire and then pull it through, then...
  4. custodian

    Cruise Control wire

    Any thoughts about getting the cruise control wire back through the steering column? I have a tilt wheel, and it doesn't look like it will be able to pull the new wire back through.
  5. custodian

    Bed prep if getting spray in liner???

    I'm looking at spraying my bed, short bed, with a liner. Approximately how much, quart wise, should I buy? I know you need a certain gun to spray it, will buy that too.
  6. custodian

    73 C10 Bed

    Thanks. I need to get the contour back when I start the body work. It was fixed before, but poorly. Same with the front fenders.
  7. custodian

    73 C10 Bed

    That top picture shows what I'm looking for. Not sure if the the 81-87 models are the same.
  8. custodian

    73 C10 Bed

    I edited my original post. I need the outside contour lines on the wheel well of a fleet side bed.
  9. custodian

    73 C10 Bed

    Should be.
  10. custodian

    73 C10 Bed

    I need a picture of a 73 C10 bed wheel well contour lines on a fleetside bed. The outside lines. . I'm getting ready to repair what was fixed before and the previous owner just made it flat.
  11. custodian

    Best Gasket Sealer

    I ended up using the Geare Oil RTV.
  12. custodian

    Caulking In Bed

    This is what I'm looking at using. ACDelco GM Original Equipment 10-2013 Body Joint and Seam Filler Compound
  13. custodian

    Question about exhaust 5.3 LS Swap

    I used the 2010 Camaro exhaust manifolds on my swap in the 73. I bought the Camaro cat delete pipes. They had the O2 sensor bungs already in them. They exited past the trans mount.
  14. custodian

    Best Gasket Sealer

    Will not be refilling immediately. I have both sealers.
  15. custodian

    Best Gasket Sealer

    I getting ready to replace the gasket on the rear end on the 85 C10. Which would be the best gasket sealer, Permatex High Tack or Permatex Gear Oil RTV?
  16. custodian

    LS Fuel Pressure

    Drove for about an hour, no codes, runs good, stopped and checked the fuel trims and were okay, what a stupid oversight on my part.
  17. custodian

    LS Fuel Pressure

    Vent is fixed and hooked back up to a charcoal canister. Not flex fuel. Reset the computer yesterday. I carry an OBD2 scanner with the the truck. Checked everything and was in normal ranges. Will drive it tomorrow and see what happens. I programmed the LS tune myself.
  18. custodian

    LS Fuel Pressure

    This is my setup.
  19. custodian

    LS Fuel Pressure

  20. custodian

    LS Fuel Pressure

    So far the numbers are staying the same. Will have to remove a few things and mount the charcoal canister on the passener side under the air box.
  21. custodian

    LS Fuel Pressure

    I hoped I solved my running rich problem. Switched the two inlet for a three inlet sending unit. Can the charcoal canister be mounted horizontal?
  22. custodian

    LS Fuel Pressure

    I have put my new sender in, fuel pressure idling is 53psi, fuel pressure idling/running with the vacuum line off is 58psi.
  23. custodian

    LS Fuel Pressure

    2002 Silverado 5.3 with stock injectors, LS swapped tune for the stock injectors with the fuel return line. i didn't check the fuel pressure with the vacuum hose disconnected from the regulator.
  24. custodian

    LS Fuel Pressure

    I hooked up my fuel pressure tester, the big gauge, the fuel pressure showed 53psi before starting and after I started it it showed 110psi. I unhooked the return line and run it in a gas can. The pressure gauge showed me 53psi before starting and 53psi after starting, and while it was idling the...
  25. custodian

    Firewall Plastic Shroud

    I have one on my 85 that had a diesel in it. Had to remove the cover over the heater/ac fan to replace the fan.

Latest posts

Forum statistics

Threads
44,163
Posts
950,682
Members
36,276
Latest member
2manysquares2care
Top