Search results

  1. fast 99

    LMC Dash Pad Supplier

    Can't remember which vendor I got mine from but it came double boxed with dashes direct part inside. It was for an 81 fit was eh.
  2. fast 99

    Engine Block Heater for SBC 350

    Good battery means adequate amperage to crank fast enough in a cold environment. Shouldn't be using heavy grade oil 10-30 or 10-40 ok, no 20-50. To remove a freeze plug, use a blunt punch of some kind or even a long 1/2" extension. Hit it towards the outside edge. It may twist in the hole...
  3. fast 99

    EGR gasket seal

    needs a gasket
  4. fast 99

    Engine Block Heater for SBC 350

    Most reliable and easiest to install are soft plug heaters. Directions will instruct which one to install it in. Remember GM installed them from the factory. I live in Spokane, we get comparable weather. Actually any maintained vehicle with a good battery should start decent in 0 degree...
  5. fast 99

    Brought home my first square body. 1980 Silverado C10. Utah

    Am sure the shows will continue somewhere else. Broadcast media is dying a slow death. 10 years from now may not be any left. I am on cable basically because most of what I watched used to be in one place. Now its horribly expensive with less content. That is unless you like watching drug...
  6. fast 99

    Little help please

    If that's all you have try to buy a donor truck to rob parts from. Buying individual items will get expensive real quick.
  7. fast 99

    Brought home my first square body. 1980 Silverado C10. Utah

    Unfortunately all those show will end. Motortrend TV is shutting down.
  8. fast 99

    Ac liquid condenser line

    Outlet is for rear ac. Might be able to weld it shut.
  9. fast 99

    TH350 Removal

    Only suggested from top because some do not have long enough extensions for the 2 top bolts.
  10. fast 99

    Ac liquid condenser line

    Just looked at my K20 I purchased same line you need last year. They had the right one then but not now. Old one I replaced was leaking at the evaporator and still does with the new line. So the line is probably ok. Might have the old one somewhere if you run out of options.
  11. fast 99

    Ac liquid condenser line

    37$ https://www.rockauto.com/en/moreinfo.php?pk=531731&cc=1052109&pt=6900&jsn=526
  12. fast 99

    Carb sputter uphill

    Fuel pressure, volume and filters. New fuel pump quality is horrible. If everything checks out [unknown what carb] possible metering rod stuck. Bouncing fuel gauge is likely caused by the gauge itself. Shouldn't be an issue provided there is enough fuel in the tank.
  13. fast 99

    Carb gasket comparison question!

    Part consolidation is a thing. Having extra holes to nowhere won't affect anything. It's only a problem when openings are sealed by the gasket. Have seen this on nearly every carb I overhauled. It's fine, use it as long as no holes are covered.
  14. fast 99

    gas tank wont fill all the way

    And then there are those new style self-sealing fuel cans. What overpaid engineer came up with those? Hopefully some of this idiocy will be curbed soon.
  15. fast 99

    California emissions removal help

    FYI even if you live in a state where vehicles aren't tested removing any emissions device is illegal. There are many threads here asking how to fix fuel smells and drivability problems after emission parts were yanked off. On a 78 most of them have no effect on performance.
  16. fast 99

    Engine stumbling/stalling in drive

    timing is set with vacuum hose disconnected, if rotor does not spring back that advance is stuck and needs repair
  17. fast 99

    Engine stumbling/stalling in drive

    Be sure and check that both advances work.
  18. fast 99

    Engine stumbling/stalling in drive

    Seems a bit more of a spread than is usual. Try adjusting the idle mix. Turn screws either in or out until highest RPM achieved then in 1/4 turn.
  19. fast 99

    Engine stumbling/stalling in drive

    Of course, vacuum leaks can be sudden as well as restricted carb circuits. Need to check both. Although I doubt it's the problem check fuel pressure and volume just to eliminate it. Idle vacuum steady?
  20. fast 99

    Starter drag when engine is warm

    Shouldn't have to modify the vehicle. If everything checks out, good battery with high enough amperage, clean and tight battery cables [no bolt on ends], all grounds intact and clean, correct timing, suspect a starter. Checking the starter off the vehicle it's not accurate. If that's how it...
  21. fast 99

    TH350 Removal

    6 bolts, 2 or more can be accessed from top with distributor out and other items removed like cruise if equipped. Distributor will usually hit the firewall anyway when the engine sags.
  22. fast 99

    never jerk a stuck truck with a chain

    After being in towing I have seen lots of broken chains and cables. Be extremely careful when under a load. Need to use properly sized equipment with good attachment points and stay in a safe area. If a person doesn't understand that you have no business pulling anything. 3/8 cable normally...
  23. fast 99

    Ultra Grey jip

    Look at the amount of filling in Oreos, most bacon packages are now 12oz not 16.
  24. fast 99

    Engine lag

    Might try disabling spark then cranking over. A cylinder not filling or low compression, starter will increase speed and be uneven on a bad cylinder. I used it many times diagnosing a misfire. Suggested what direction to proceed with diagnosis. If available hook up a vacuum gauge.
  25. fast 99

    Tire size confusion.

    We had several C and K 30's-year range was 74-85. We did run 235's on a couple trucks but with either low air pressure or high weight sidewalls would rub. This is a totally bad thing in DOT's mind. We never got red flagged [parked], but that was a distinct possibility. State Patrol was a little...

Latest posts

Forum statistics

Threads
44,163
Posts
950,654
Members
36,276
Latest member
2manysquares2care
Top