Search results
-
Valuable car insurance information for squarebodys
Good little blurb thanks!- Tank6x2
- Post #2
- Forum: Tech Discussion
-
1984 K10 Water Temperature Gauge Malfunction, Max Out Then Drops
Check the eyelit connection clean it and restest it, could be the sensor, could be the printed circuit board on on the back of the cluster.- Tank6x2
- Post #2
- Forum: Tech Discussion
-
-
-
-
Replace idiot lights with gauges.
You may need a new circuit board for the cluster, obviously the gauges and may possibly need to run additional wires in the harness to each function/component depending on how your unit was originally wired and installed. Best bet is to grab a circuit diagram off of the forum here, figure out...- Tank6x2
- Post #2
- Forum: Gauge, Speedo & Instrumentation
-
-
Door latch
Any chance the door opened abruptly since you’ve owned it, ie: wind day and flung open- Tank6x2
- Post #2
- Forum: Introduction
-
Muncie 4 speed grinding
You K.I.S. ? Check the lube level in the Muncie by chance? How about lube level in diff? Lift the pumpkin and see how quickly the opposite wheel turns - maybe a bit of preemptive playing the gears of the diffs- Tank6x2
- Post #2
- Forum: Transmission & Transfer Case
-
Dash/Stereo Progress and Wiring Question
Actually installing a legitimate alarm and a kill switch - flat screwdriver and these beauty’s are gone- Tank6x2
- Post #2
- Forum: Electrical & Audio
-
Axle housing plugs
Yeah it happens- you can mug them or tig if you really want to.- Tank6x2
- Post #2
- Forum: Differential & Driveline
-
-
New guy Visalia CA
Wow dude! That’s a sweet ride and a great accompanying top with it!!! o_O- Tank6x2
- Post #2
- Forum: Introduction
-
Spider Gear Thrust Washers
Try gear centre in Edmonton Alberta Canada, they may be able to give some guidance where to get them if they don’t have them on the shelf - try rock auto by chance??- Tank6x2
- Post #2
- Forum: Differential & Driveline
-
Nv4500 shifter and boot
Beauty specimen! Not looking but great deal for someone! -
Turbo 400 to np208 adaptor
Good deal - you going a different route or update? -
TIGHT door hinge
I have, little heat to the rollers - they seem to not take the lube very well but little heat and Kroil penetrating fluid does wonders- Tank6x2
- Post #2
- Forum: Paint and Body
-
Air bag question on an 84.
Go look at pg 4-6 actually https://www.gmsquarebody.com/posts/707594/- Tank6x2
- Post #3
- Forum: Lowered & Street Systems
-
Air bag question on an 84.
Go look at https://www.gmsquarebody.com/posts/707594/ I think page 14-17- Tank6x2
- Post #2
- Forum: Lowered & Street Systems
-
-
700R4 that only mildly backs up at 1200 rpm
Sounds like a plugged flow port, drop filter and check valve ports - may be assembled with debris.- Tank6x2
- Post #2
- Forum: Transmission & Transfer Case
-
-
81 c10 inline 6 casting numbers?
Copy and Pasted, Locate the engine block code. This series of seven to eight digits begins with a letter and is stamped directly on the engine. Look behind the distributor on the passenger side of the block if it is a six- cylinder GM engine. Look at the first digit, which will be a capital...- Tank6x2
- Post #2
- Forum: Engine & Performance
