Search results

  1. 80BrownK10

    1978 k10 radio patch panel

    Haha, are you kidding me! :Big Laugh: :33:
  2. 80BrownK10

    1978 k10 radio patch panel

    I am not sure I have ever seen one of those? I guess your going to have to hack out an intact dash and weld into yours?
  3. 80BrownK10

    Weatherstripping

    Think I used precision, but I did what any guy would do. Got on eBay and sorted cheapest first and bought that one! :Big Laugh:
  4. 80BrownK10

    Where to find Bed Bars

    My truck still has the holes in the bed from where it had one of those mounted in the 80s-90s
  5. 80BrownK10

    How do new cars connect to internet ?

    I don't own a vehicle that even knows what connecting to anything besides an OBD2 scanner is!! My newest vehicle is 18 years old. Oldest is the square at 42 years old!
  6. 80BrownK10

    How do new cars connect to internet ?

    Satellite antennas can be little puck things stuck to a roof? Ever seen a GPS antenna for a held held unit? Ever seen a boat GPS antenna, there like round bowl things. Ever seen a satellite radio antenna, the one on my wife's care is a little magnetic puck like about 2"x2" and not an inch tall...
  7. 80BrownK10

    Dual tank question

    I didn't think the single wire valves were available?
  8. 80BrownK10

    Filling a k10 wheel well, best wheel to tire ratio

    It's been so long I'm not sure what exactly we're debating. But you could have an 80 with round headlights....but it for sure is the only year with single large square headlights.
  9. 80BrownK10

    Trany or Engine

    I bet it's the tranny. That trans should easy start out that light if a trailer. A 383 with 4:11 should be able to burn out with that trailer sitting on that truck. I can pull 9000+ pounds of firewood on my trailer with .h 350/350/205 combo with 3.08 gears and 33" tires!! It's not fast to speed...
  10. 80BrownK10

    New oilpan + one piece gasket help

    Well I do have a passenger side dip stick. And I have 100% two piece rear main because I replaced it about a year ago!
  11. 80BrownK10

    New oilpan + one piece gasket help

    I think it was late 80 or 81? Well your probably right. My truck is an 80 but it's not the original block and who knows what it's out of. I have the older style and a two piece rear main.
  12. 80BrownK10

    New oilpan + one piece gasket help

    Well I'm late and I see that we already had this covered about a week ago!
  13. 80BrownK10

    New oilpan + one piece gasket help

    Are you sure it's the correct gasket? There two styles, one for the different pans the older style and newer style. There is different size humps for different year blocks.
  14. 80BrownK10

    Exhaust opinions and discussion

    If you don't drive it much and high speed drone won't drive you crazy I would cut it all off before the mufflers and just put turndowns and hangers if you need them to keep the pipe still. It will free flow more and be cheaper and you will be done with it. You probably have a lot more pipe that...
  15. 80BrownK10

    Oil Sending Unit Help

    You can buy them anywhere, eBay, Amazon rock auto, O'Riley, AutoZone or advance.
  16. 80BrownK10

    Holy Grail of Squarebodys

    All those one ton and more Ford's clunk and knock over bumps.
  17. 80BrownK10

    Holy Grail of Squarebodys

    So useing that math Cummins as a company was only worth like 13 millions dollars in 1997??? That seems way to cheap.
  18. 80BrownK10

    TBI 350 bracket below A/C compressor empty?

    In California, I would assume it had the smog pump. Look to see if there any pipe plugs in the exhaust manifold where lines would of connected or somewhere else in the system.
  19. 80BrownK10

    Zinc, Engine oil and flat cams

    Not to side track this...ah what the heck that's what a good forum does. What was your warm oil pressure at various operating conditions. I really only care about warm or operating temps. Idle, cruising etc?
  20. 80BrownK10

    Quadrajet question

    If Holley was the best carburetor wouldn't GM have just pulled a Holley off the shelf and put it on their truck in the first place. If it got the best MPG and power that they could get they would have just used an off the shelf carb and saved all the time designing another carb. Especially early...
  21. 80BrownK10

    What type of transfer case do I have in my truck ?

    So you didn't know your truck was full time 4wd? Your shifter will only have 4wd positions. Or is this a truck you just got and are building?
  22. 80BrownK10

    spark plugs.... Over thinking!

    Hey are we the same person??? Haha:Big Laugh: Sounds a lot like how my jobs always go minus the beer and all the pissing!
  23. 80BrownK10

    spark plugs.... Over thinking!

    Diesel oil in a worn outb305 is not going to cause any issues that are not already there. These engines can easily run that oil no problem new let alone worn in.
  24. 80BrownK10

    Replacement fuel filler necks and hoses

    I got one from the junkyard for a guy here one time. Looked decent and serviceable for as old as it is. I'd say grab them at the junk yard when you see them. There not much. There. You would want to make sure they are better than what you have before you pull them obviously
  25. 80BrownK10

    Oil shooting out dipstick when driving over 50mph

    Anyone know what a "flame trap" is?:33:

Latest posts

Forum statistics

Threads
44,163
Posts
950,648
Members
36,276
Latest member
2manysquares2care
Top