Search results

  1. MrMarty51

    Idles fine but stalls when put in gear!!

    Accelerator pump is bad. Remove air filter cover, look down the bores, open throttle, should see fuel spray into the front bores of carb.
  2. MrMarty51

    What's the most dangerous tool in your shop?

    You beat Me toooit. Nothing more dangerous in My garage than My ability to do stupid stuff.
  3. MrMarty51

    What have you done to your square lately??

    I am watching more snow falling on the 78 K20. That's about all.
  4. MrMarty51

    Bvllsh!t on craigslist.

    I think it`d be a fortune maker to get one of those 900 numbers, list it as 1-900-insults or some such. For those that can not live without their daily insults.
  5. MrMarty51

    Bvllsh!t on craigslist.

    This aint C.L. but it might get some ones attention in here. http://www.thetruckstop.us/forum/threads/1986-4x4-gas-burb.46869/
  6. MrMarty51

    1987 TBI wont start, no spark, but has fuel

    I`ll sell You a 91 K1500, everything is there, just needs the engine gone through, or another engine. A no rust unit too.
  7. MrMarty51

    1987 TBI wont start, no spark, but has fuel

    That TBI 350 will run for a very long while if it is taken care of. It will drink a whole lot less fuel too. The 87 K1500 that I once had would get 17 to the gallon, I will guarantee You will never get that from a BB. The four barrel sniper system might be a nice upgrade for the 350 though...
  8. MrMarty51

    Im a 6.2 Diesel guy

    Welcome to the forum Dakota. I recently tried to buy a CC square body 2 wheel drive that has a 6.2 in it. I love Me some diesel. My current main truck is a 2000 K3500 with a 6.5 and has a few nice uprated components added.
  9. MrMarty51

    1

    Nice build You have going there. I`d like to find a nice CC body to convert My stuff over to.
  10. MrMarty51

    350 to 400 small block

    I once did a 350 with three deuces into a 72 Vega notch back. It was quick
  11. MrMarty51

    350 to 400 small block

    I have a 400 SBC setting in the shed, bored .030 over and ready for fitting pistons. It has the main bearing caps too. No heads, not rotating assembly, just the block. If You know of someone getting near Billings Montana, I could send it along. I live 150 miles to the east of there but could...
  12. MrMarty51

    New Member and New to Chevys

    I love diesel, I love new diesel in old trucks. Welcome to the forum and yes, please post pics of the progress, curious minds wants to watch.
  13. MrMarty51

    New swap project in the planning stage right now

    Whatever way You go, have one four weeeel drive.
  14. MrMarty51

    TBI rough on a warm or hot restart

    Could be the temp sensor or the O2 sensor.
  15. MrMarty51

    6l80e

    It might require some sort of a shift programmer.
  16. MrMarty51

    89 Trans Am

    You did tighten that drain plug, yes ? :happy175::happy175::happy175::happy175:
  17. MrMarty51

    is this normal?

    That is a sign of bad spark plug wires and or bad plugs. The resistance is backing up the voltage in the form of heat and too much spark jumping around in the cap.
  18. MrMarty51

    1st TBI Conversion Help Needed

    Almost sounds like a timing issue. Is the brown or tan with the black stripe hooked into the system ?
  19. MrMarty51

    1987 TBI wont start, no spark, but has fuel

    I believe it is tan with a black stripe, Do not remember where it is located on the V model of trucks though.
  20. MrMarty51

    1987 TBI wont start, no spark, but has fuel

    Get the timing set first then see what it does. If the misfire is still there then see what a compression test tells You. Welcome to the forum Alex.
  21. MrMarty51

    What have you done to your square lately??

    Dismantled a 203 NP T-Case to get the HI-LOW gears from it. Now have the old brown truck in the garage, pull the T-Case to get to the gears. I just in the last couple of years, about ten miles ago, installed a rebuild kit and a part time kit in the box. Never knew it jumped out of four low...
  22. MrMarty51

    no engagement in any gear help please!

    Does the transmission actually pop out of gear, or the transfer case ? Welcome to the forum Sally.
  23. MrMarty51

    UNINSTALLED NEW GM FRONT FENDERS, WHATS THEY WORTH ?

    Looked it up, appears they fit 73 to 80 years. This guy has $750.00 for one fender. I did not ever see any gold in these when I was shuffling them around. :happy175::happy175::happy175: http://cooperstrucks.com/swapmeet/c5fd83b3-8233-4ec3-a5e7-4e098bc116f5
  24. MrMarty51

    UNINSTALLED NEW GM FRONT FENDERS, WHATS THEY WORTH ?

    I have a set of new original front fenders for a square body, curious as to how much they are worth is all. Never know, might decide to sellum. They are a bit dusty from setting, there is no rust.
  25. MrMarty51

    Hello all hope you don’t get tired of me

    :welcome:

Latest posts

Forum statistics

Threads
44,166
Posts
950,714
Members
36,280
Latest member
rodfarm
Top