Search results
-
Project 383
Iron are cheaper and really to me when your talking 6000 pound truck I don't care if I'd save a lil weight with aluminum I know aluminum disapates heat faster still scares me mixing aluminum with cast iron jmo- 87scotty
- Post #9
- Forum: Engine & Performance
-
Project 383
I've been looking at cast vortecs they seem to be best bang for buck aim is 400hp 400tq for 4000$- 87scotty
- Post #5
- Forum: Engine & Performance
-
-
Is blower motor supposed to be off when off?
Occasionally a melted plug but yea somthins burnt up -
-
Spring Tuneup
I use the differential rtv mostly cause I like the grey ring it leaves around my pumpkin but same here goober up smash it on fill er up and keep on truckin- 87scotty
- Post #16
- Forum: Engine & Performance
-
Spring Tuneup
Limited slip needs a certain type of fluid- 87scotty
- Post #13
- Forum: Engine & Performance
-
-
-
Newbie: Idles rough, stalls when put into gear!
I would just start with all the obvious wear parts- 87scotty
- Post #42
- Forum: Engine & Performance
-
Newbie: Idles rough, stalls when put into gear!
Almost sounds like your lacking fuel cooler air requires more fuel my snowmobile ran really good in below 0 temps and terrible at 30degrees come to find out po had jetted it and it was getting way to much fuel! Your problem sounds like the opposite- 87scotty
- Post #41
- Forum: Engine & Performance
-
What have you done to your square lately??
Pro less drag on motor frees up a horse or two better mpg con none that I can think of you'll want to put em on a thermostat screw using a switch -
Spark plug wire recommendation
Napa carries there own brand of plugs there great quality and also seems to carry better options of parts if you buy the cheapest I'm sure there junk- 87scotty
- Post #14
- Forum: Engine & Performance
-
-
Spark plug wire recommendation
Napa to me is 5 times better quality parts than any other parts store- 87scotty
- Post #12
- Forum: Engine & Performance
-
Spark plug wire recommendation
Auto zone is about as cheap as you can find that's like harbor freight and napas like craftsman- 87scotty
- Post #11
- Forum: Engine & Performance
-
Newbie: Idles rough, stalls when put into gear!
If its caroded replace if clean its probably fine! But I'm guessing there will be some buildup- 87scotty
- Post #17
- Forum: Engine & Performance
-
Newbie: Idles rough, stalls when put into gear!
Not really if its a more recent thing I'd less suspect timing unless distributers not tight- 87scotty
- Post #15
- Forum: Engine & Performance
-
Spark plug wire recommendation
If its a stock motor through some napa wires on it and call it good- 87scotty
- Post #9
- Forum: Engine & Performance
-
Newbie: Idles rough, stalls when put into gear!
Deffonetly sounds like a timing issue to me- 87scotty
- Post #13
- Forum: Engine & Performance
-
-
Filling holes in dash, light switch locations?
Just weld it.or pay to get er done on the big hole so quick and easy -
-
Whats all needed for a 4 inch lift?
And steering arm, driveshafts should be fine extend your vent tubes on axles- 87scotty
- Post #3
- Forum: Lifted & Off-Road Systems
-
Whats all needed for a 4 inch lift?
Mines got a BDS and all rancho shocks I'm happy with it- 87scotty
- Post #2
- Forum: Lifted & Off-Road Systems
