Search results

  1. iamtherealJayy

    Quadrabog bogs

    Where on the carb should I hook the vacuum gauge to for manifold vacuum? I’m not familiar enough with q-jet vacuum routing. I added coolant last night and I’ll work on it again later I just don’t know which port is manifold.
  2. iamtherealJayy

    Quadrabog bogs

    Also not positive how important it is, but the ground strap from the frame to the back of the cab is not connected it is broken at the eyelet.
  3. iamtherealJayy

    Quadrabog bogs

    One of you says looks normal one says too tight, I can possibly loosen it some?
  4. iamtherealJayy

    Quadrabog bogs

    I worked on the belt and used my flat bar to move the alternator over a little more and it isn’t squealing. But I’ve got more problems after that as well. Still not charging and I can hear and exhaust leak tick under throttle. Although not white smoking today it still did get warm.(haven’t added...
  5. iamtherealJayy

    Quadrabog bogs

    At idle I saw the flap was open, but get watching the video again I noticed it closes after letting off throttle. Here’s the video of the carb as I’m giving throttle.
  6. iamtherealJayy

    Quadrabog bogs

    Alright finally got time, the rear driveshaft slip joint has some play all the ujoints are are tight but the slip joint has slack. The choke is opening fully and under WOT how much do the secondary doors open? They’re way harder to open with the engine running than they were the other day. They...
  7. iamtherealJayy

    Quadrabog bogs

    I’m not too familiar with quadrajet vacuum hose routing, where should it be ran to and what’s missing? I’ll replace what’s missing yo keep this truck going how it’s meant to run. Also what gear do I need to be in for testing the ujoints
  8. iamtherealJayy

    Quadrabog bogs

    Oh trust me oil is dripping from every low spot including the starter and the oil drain bolt. But I’m having a scenario similar to the 78 where oil going up and onto the intake manifold lol. Im gonna buy yet another timing light so I can see where this one is at and redo the intake gasket on the 78.
  9. iamtherealJayy

    Quadrabog bogs

    I can tighten them a little bit later on, I’m on lunch right now. I’m hoping they aren’t the torx bolts but I haven’t even looked. It leaks a healthy bit of oil but I’m starting to think that’s just common on these. There’s a sticker in the window dated back in 2020 that said next oil change at...
  10. iamtherealJayy

    Quadrabog bogs

    What makes you think this truck needs an intake gasket? I can tighten them when I get off work but the truck runs smooth in neutral and park my only problems are in reverse and drive.
  11. iamtherealJayy

    Quadrabog bogs

    No it was in park the truck turned off and trans in park. No one specified if I needed to be in a certain gear and I was alone so I felt safer leaving it in park lol.
  12. iamtherealJayy

    Quadrabog bogs

    I don’t know how relevant this is but the truck also doesn’t move in gear on its own it takes a fair bit of throttle to get rolling, it may be a trans issue or not running ideal or that I’ve just never had one of these trucks in automatic
  13. iamtherealJayy

    Quadrabog bogs

    Both driveshafts feel stiff with no movement in any direction including rotating. I checked the oil again and it looks great little dark could probably use a change but it doesn’t look like a Reese milkshake. I didn’t see anything that looks like an obvious vacuum modulator but I didn’t look too...
  14. iamtherealJayy

    Quadrabog bogs

    I’ll have to google about the modulator to see a picture since I have 0 idea what I’m looking for. I’ll go shake both driveshafts now.
  15. iamtherealJayy

    Quadrabog bogs

    How could I verify ujoint? Watch under the truck when someone puts it in gear? The front one has been replaced at some point it’s too shiny looking to be original. How do I check the “diaphragm on the vacuum modulator on the tranny”?
  16. iamtherealJayy

    Quadrabog bogs

    @SirRobyn0 ive watched the video, I rewatched them just now. This truck starts right up idles just fine and all except the in gear wot. I’m not sure if it was audible in the video but is a like bell sound common after switching to drive or reverse? The truck makes a ding kinda sound after I put...
  17. iamtherealJayy

    Quadrabog bogs

    I’m 100% fine with running a quadrajet. I think it’s a great carb when done right. Everyone goes edelbrock for simplicity and holley for performance my honest opinion. This truck is based solely around reliability and fuel economy.
  18. iamtherealJayy

    Quadrabog bogs

    I checked the oil the other day and it looks fine. Not like a Reese milkshake. I’ve tightened it as much as I can by myself I’ll have to have someone pry it over while I tighten bolts and try again
  19. iamtherealJayy

    Quadrabog bogs

    I’ll work on getting a timing light asap since I need it to redo the timing on the 78 when I change intake manifold gaskets. I have a multimeter and a vacuum gauge. I’ll t into a vacuum line with a gauge after it cools. The battery is obviously too small for the truck in my opinion. The...
  20. iamtherealJayy

    Quadrabog bogs

    Here’s some photos regarding the smoke. Coolant is low, I just changed the heater core so it was freshly filled. There is moisture in the exhaust, and it is really black in the exhaust.
  21. iamtherealJayy

    Quadrabog bogs

    Yes that is what I did, the smaller annoying flat head screws are the mix screws the nice bigger flat head screw attached to the throttle linkage is the idle speed screw.
  22. iamtherealJayy

    Quadrabog bogs

    Alright I take it back. The water neck is wet, that’s where the coolant went. Can fuel make a white smoke? I thought fuel made a black smoke? It’s pretty good smoke show at idle but any amount of throttle blows it right away and it takes a second to come back. Is there anyway I can verify...
  23. iamtherealJayy

    Quadrabog bogs

    I don’t feel as I’m concentrated enough to do the rpm tuning. And my cheap $25 tachometer isn’t precise enough. I’m not sure if you’re referring to the smoke as not good or my tuning as not good. Neither seem too great in my opinion. I admit I think I made it better but I just can’t wrap my head...
  24. iamtherealJayy

    Quadrabog bogs

    I have no idea on timing. My timing light disappeared somewhere between work and home. It bogs on throttle and it’s too loud to really tell exactly when it stalls but I’m off the throttle when I realize it’s dead. So I’m going with bog on throttle and stalls when you let off. I’m thinking the...
  25. iamtherealJayy

    Quadrabog bogs

    No no no lol I completely redid it because I felt like I was wrong the first time. The first time I kept unscrewing them because the idle kept going up. I then restarted back at 1-1/2 and did the process all over. This time I got to about 2-3/4 turns out then turned them back in more than a full...

Latest posts

Forum statistics

Threads
44,163
Posts
950,648
Members
36,276
Latest member
2manysquares2care
Top