Search results
-
Instrument Bezel Referb
I used a paint pen. Still hard to make it look great but it was an improvement. Paint pen from craft section at wal mart I think -
new member '86 C10
Welcome from indy.....and a frequent sw mich visitor.....st joe. S haven , Ludington etc- Ken B
- Post #10
- Forum: Introduction
-
-
-
-
85 K10 donor and parts for sale
PA turnpike west to 1-70 west to indy.....hahahaha -
-
engine bay wiring- routing
so I have both,,,,what is the dummy switch doing there if there is a guage?- Ken B
- Post #21
- Forum: Electrical & Audio
-
85 K10 donor and parts for sale
give bucket the idea he needs everything but the bed...ohio is a neighbor to PA..hahahaha -
85 K10 donor and parts for sale
actually Bucket has seen this truck. he and I had a meeting and he was surprised I was taking apart a perfectly good truck. -
85 K10 donor and parts for sale
keep up the column hunt , good luck, I never knew that was so rare. -
-
Instrument cluster lights
thanks I will give that a try. but these LEDs are so much brighter I might not need any more .- Ken B
- Post #8
- Forum: Tech Discussion
-
Instrument cluster lights
I am trying to get the instrument cluster lights working, some do some don't, anyone have any tricks to getting the individual lamps to work? I am replacing bulbs with LEDs , i am about at 60% working......- Ken B
- Post #6
- Forum: Tech Discussion
-
85 K10 donor and parts for sale
I have an 85 K10 that I used for my donor, needed cab and engine. It is time for it and other parts to go. If I don't need it it goes. Not looking to part out. Someone who has the time and space could probably part out and make some good money. Need it all gone at once. 90% of the parts... -
-
How... do you build a stepside?
here is a pic of the bottom of my bed if that helps at all -
Wiring--Engine Heat Protection
I saw the spark plug shielding and thought it might work. You just confirmed it.- Ken B
- Post #4
- Forum: Electrical & Audio
-
Wiring--Engine Heat Protection
Wondering what's good to use to protect wiring to the starter to keep from getting damaged by exhaust or engine heat?- Ken B
- Thread
- Replies: 12
- Forum: Electrical & Audio
-
engine bay wiring- routing
So i would like to just have a temp sensor on the side of the block. So its ok to delete the one on the manifold?? I would prefer to have the stock gauge in the dash be working off the sending unit. Is there any benefit to keeping the dummy switch connection?- Ken B
- Post #20
- Forum: Electrical & Audio
-
engine bay wiring- routing
So this is coolant sensor correct? (2nd pic) between 1st and 2nd cyl on the drivers side the new harness has a single flat "female" plug so a new sensor with a single spade would be correct. I think there is also one on top of the manifold (1st pic) with short pig tail. I would like to delete...- Ken B
- Post #18
- Forum: Electrical & Audio
-
engine bay wiring- routing
Ok so I see the round cyl sending unit, I also see what i have heard described as the oil pressure switch for the dummy light, can anyone shed some light on this as i am confused as how they can both be there. Thanks In advance- Ken B
- Post #15
- Forum: Electrical & Audio
-
In dash connections
at this stage I am not worried about radio, just trying to get essentials connected, tunes later.- Ken B
- Post #5
- Forum: Electrical & Audio
-
In dash connections
thanks. i was upside down looking at steering column connections.... I have the original radio on a shelf I will compare.- Ken B
- Post #4
- Forum: Electrical & Audio
