Search results

  1. MarineOne

    Do you need a new windshield washer motor

    Thanks . Mine just stopped working on the variable settings
  2. MarineOne

    Interior Vents

    That makes it even easier. If compressor has a sticker it should say howmany lbs/Oz it should be charged with. If not contact the kit manufacturer and ask what the charge weight is and if they have a line pressure chart
  3. MarineOne

    75 k10 compressor upgrade from a6 to ht6

    retrofit can be done one of two ways. The first is to follow the vehicle manufacturer recommended retrofit procedure. This generally involves removing all the old mineral oil from the system, replacing the accumulator or receiver/dryer with one that contains X-7 desiccant, replacing O-rings (if...
  4. MarineOne

    Interior Vents

    They font need any ducting to charge the ac. It's all done via line pressures and ambient temp. Is your ac factory with r134a conversion fittings and orifice tube or aftermarket?
  5. MarineOne

    1990 Suburban Bagging/Wheel Size

    How low?
  6. MarineOne

    Steering column parts I'm replacing.

    Needed this. Thankyou
  7. MarineOne

    Steering slack

    Check out off road design. They can make you a custom leaf pack or tough country has ez ride springs
  8. MarineOne

    Original brake Parts?

    Yes that's original brake parts
  9. MarineOne

    1986 Chevy K10 with big Block which headers will work

    I'd look into Doug's headers. Best fitting and if you give em a shout they will know exactly what u need. Patriot is same as Doug's just different product brand. Idk why
  10. MarineOne

    1976 C30 Trailer Brake Controller

    Pretty easy instal I have linked the products I would use. They just tap into factory tail lights https://www.etrailer.com/Accessories-and-Parts/etrailer/ETBC7.html https://www.etrailer.com/Brake-Controller/Chevrolet/C%2FK+Series+Pickup/1976/90885.html?vehicleid=1976202925
  11. MarineOne

    Carb to mounting plate torque specs

    I'm guessing your doing a Rochester to square bore adapter? If you are I recommend finding one with bolts through plate vs the stud ones.
  12. MarineOne

    Front drive shaft

    I'm not sure but if you call dennys driveshaft 716-875-6640 they can help you and have any part you'll need https://www.dennysdriveshaft.com/
  13. MarineOne

    trouble dimming LED panel lights?

    Needed this. Thanks
  14. MarineOne

    none

    Nice
  15. MarineOne

    Rough idle/ intermittent starting problems

    Based on codes your getting I'd start chasing wiring harness and look for any issues. Also that 02 spacer isn't needed and could cause more issues It's designed to run around 650 degrees. Also the sensor should be 4-10 inches from collector where primary tubes connect Collector gasket leak...
  16. MarineOne

    Limited steering

    Thanks for the help. Yall suggestions sorted out the issue. First time ever dealing with a drag link steering. Figured it was same principle as a y link but wanted to confirm
  17. MarineOne

    Limited steering

    It's like 3 to right 1.5 to left. Locks are set properly. I'm sure box isn't centered I was mostly curious if extending the drag link will center box to allow more left turn
  18. MarineOne

    Limited steering

    Hey guys so I have an issue that I'm sure is common but can't find any good answers. I have full steering right and about half steering to the left. Steering wheel is about 1/3 turn to the right. Drag link is as short as possible. Truck goes down road straight My question I guess is will...
  19. MarineOne

    Dual fuel tank filling

    I just blow it out real well if it had gas recently I will parts wash it and dry it good
  20. MarineOne

    WTH! CRACKED FRAME AT PS GEARBOX. Whats the fix. Check it out.

    Drill hole at each end of crack Gouge and weld the Crack then plate it with a steering box reinforcement plate
  21. MarineOne

    12 Bolt Rear End

    If your in market to swap one from newer truck I'd recommend 2014 amd newer chevy/gmc it has 3.73 gears, auto locker, disc brakes and best of all a 9.75 ring gear. It's way stronger than the 8.5 10 bolt. You'd need to move spring and shock hangers but that's not a huge task
  22. MarineOne

    Rear-end shot

    What gear ratio?
  23. MarineOne

    Update on c10 454 a.i.r.belt

    Float level? Needle and seat ? What carb? fuel pressure set off idle?
  24. MarineOne

    High Amp Alternator

    It wouldn't hurt. That's alot of strain on current alt
  25. MarineOne

    Shopping parts in SoCal?

    I've always had best luck going directly with summit. Can't beat their prices

Latest posts

Forum statistics

Threads
44,163
Posts
950,650
Members
36,276
Latest member
2manysquares2care
Top