Search results
-
My new truck. 1980 GMC k3500 4x4 DUALLY
Welcome from Austria. Nice Truck.- ali_c20
- Post #16
- Forum: Introduction
-
-
-
New to this: Rear end alignment?
I like the upper case.... :D- ali_c20
- Post #4
- Forum: Suspension, Steering & Brakes
-
-
HOW GEAR OIL?
80W-90 GL5 in my K5 12 bolt with limited slip and my C20 14bolt ff with open diff.- ali_c20
- Post #17
- Forum: Differential & Driveline
-
-
-
-
New guy from Tacoma, WA
Welcome from Austria. A post in the introduction forum without pics didn't happen.- ali_c20
- Post #7
- Forum: Introduction
-
-
1987 GMC Suburban
Welcome from Austria. Get a repair manual and a book for rebuilding small block engines. Best would be a shop manual.- ali_c20
- Post #2
- Forum: Introduction
-
New from Idaho
Welcome from Austria. Best place for questions here, this forum is a well of truck knowledge.- ali_c20
- Post #2
- Forum: Introduction
-
New Guy Jacksonville Fl
Welcome from Austria. Pics, we want pics.- ali_c20
- Post #7
- Forum: Introduction
-
-
Front Crossmember Degreasing
What I did to my crossmember: Clean. Blast. Primer. Paint(2k). Cavity sealer on the inside. I used a grease based sealer which has to be heated before applying it.- ali_c20
- Post #3
- Forum: Suspension, Steering & Brakes
-
VDO Series 1 3-3/8 inch Gauge
The part number is VDO 333 355. All bezels of the VDO 333 series 1 should fit. -
Hubcap Paint
From One Shot it's 191 imitation gold. https://www.1shot.com/One-Shot/colors/Lettering-Enamels.aspx- ali_c20
- Post #3
- Forum: Paint and Body
-
-
Hooker small block manifolds
I'm sure a machine shop could drill and tap them for the smog pump.- ali_c20
- Post #15
- Forum: Engine & Performance
-
-
Just want to make shure im reinstalling new control arms correctly.
I have a C20 and my control arms look exactly like the ones in your pictures. The upper control arms are identical except the bushings and ball joints, the lower ones have different stamping for the shaft with the nuts. Try If the ball joints fit into your spindles.- ali_c20
- Post #4
- Forum: Suspension, Steering & Brakes
-
Hooker small block manifolds
Thanks. I think they will fit with a full size starter but I would be really close. I have a Powermaster gear reduction starter which gives enough clearance all around. The Hookers are universal so they should fit a 85 C10 with a 305. I can post more pictures or measurements if you want.- ali_c20
- Post #12
- Forum: Engine & Performance
-
New Guy from Washington State
Welcome from Austria. Nice truck.- ali_c20
- Post #12
- Forum: Introduction
-
Just want to make shure im reinstalling new control arms correctly.
This control arms are for 3/4 and 1 ton trucks. The ball joints are different in size for C10 and C20/30 trucks. They don't work on a C10 Truck. Control arm shaft can not be rotated by hand. Insert a big screwdriver and they should move. If they don't move loosen the big nuts and adjust the rods...- ali_c20
- Post #2
- Forum: Suspension, Steering & Brakes
