Search results
-
73 tilt for turbo 700 trans
You installed a 700R4. Not a turbo 700. :) I put a '91 tilt in my '66 C10 so yeah it can be done. Just takes some modification. In my case, the newer column was quite a bit fatter than the '66 column. What I did, 1- cut the mounting ears off the collar that attaches the old column. 2- bolt...- BigPip
- Post #2
- Forum: Suspension, Steering & Brakes
-
Numbers on ring gear
They tell you the gear ratio. The 40 is the number of teeth on the ring gear. 13 is the number of teeth on the pinion gear. 40÷13=3.07682308. You have a 3.08 rear end. They're installed as a set so both numbers are stamped on the ring gear.- BigPip
- Post #2
- Forum: Differential & Driveline
-
heater lever issues
My fix for the connector. It's made out of a steering alignment shim from a 2wd '66 C10 I had laying in my miracle pile. The original that's been JB Welded is beside it. While letting it cure, I decided that wasn't good enough. It'll never brake again. Cable or blend door might but that...
