Zelph's latest activity
-
ZSince there’s no inner u-bolt against the diff, the axle pictured is either a D60 or a Dodge D44 as both of these had studs or bolts on...
-
ZZelph replied to the thread Aftermarket tranny cross member.https://tejassteelworks.com/product/high-clearance-transmission-cross-member-2wd/
-
ZJust run it through the regular hole by the bulkhead.
-
ZZelph reacted to legopnuematic's post in the thread Will a 8.5 Camaro 10 bolt axle fit in a 1981 squarebody? with
Like.
A Camaro should be a 5x4.75 bolt pattern, a 2wd 1/2 ton is 5x5 bolt pattern. Meaning you need different wheels for the rear, or change... -
Z1973-1977 or 78 the brake light switch is just for the proportioning valve. My 79 has a switch on the parking brake pedal. My 76 does...
-
ZFront: 18x8 with 245/45 and a 1.5" spacer Rear:18x9.5 275/40 and a 2" spacer Spacers are made by BORA @...
-
ZZelph replied to the thread 14bolt FF size vs 10bolt..
-
ZZelph replied to the thread 14bolt FF size vs 10bolt.For an 8 lug front, the hardest part to source will be the backing plate. No known aftermarket repops at this time. You’ll need a large...
-
ZZelph replied to the thread front wheel barings.What front axle do you have?
-
ZZelph replied to the thread Buying a rebuilt transmission th350.All turbo 350 are 27 spline output. Check how far the output shaft sticks out. 2.5 inches is correct for the 208. The 203 and 205 are...
-
ZZelph replied to the thread 14bolt FF size vs 10bolt.That there is a 208. I wouldn’t buy any u joints on assumptions. Get a set of calipers and measure what you have and buy accordingly...
-
ZZelph replied to the thread 14bolt FF size vs 10bolt.I’m thinking he has a 208. If not, we need to figure out what front axle he has.
-
ZZelph replied to the thread 14bolt FF size vs 10bolt.What side is your front driveshaft on? Or the front axle differential?
-
ZZelph reacted to DoubleDingo's post in the thread Replace front Seal in SM465 with Trans in Truck? with Like.
I would recommend unbolting the bell housing, bracing the trans and transfer case in place, remove engine, reseal engine, reseal...
-
ZZelph replied to the thread 14bolt FF size vs 10bolt.NP 208 transfer case? Weld in new spring perches with the proper pinion angle. Measure and order a new driveshaft from a vendor of your...
-
