Zelph's latest activity
-
ZZelph replied to the thread General Bolt Size Master List.https://www.amazon.com/dp/B0D1CBSBLF/
-
ZZelph replied to the thread k5 rear window.Thats how it is. 1) live with it 2) soft top and pickup tailgate 3) fabricate a lift hatch like the 1st gen had.
-
ZTest it. Pour water over the Windshield, if it stays dry pour water in the cowl. This way you can find where the leak sits.
-
ZThat's the route I would go if I were you. Just wanted to add this... Be realistic about it, adding any type of locker isn't going to...
-
ZZelph replied to the thread Engine Crossmember Replacement.I may still have one that came out of a K5. I can get out to the shed and look sometime this weekend if weather is ok. I don’t know if...
-
ZZelph replied to the thread Building a new motor for my 79 C10 - would love some advice!.What is your gear ratio in the rearend?
-
Zthe module is available here - https://www.workhorseparts.com/15598496-Module-Asm-Wiper-Switch-Pulse-Control. I've also had the...
-
ZZelph replied to the thread Bowler Clutch pedal?.The bowler kit is a nice piece. You won’t have buyers remorse if that’s the route you choose. Being in Rocklin and your proximity to...
-
ZNo comment on tires, but if you have the option still, I’d not use Rough Country springs unless you’re after the Roughest ride possible...
-
ZZelph reacted to Rustisbest's post in the thread What have you done to your square lately?? with
Like.
Got the 10 bolt deleted. Got too hot so I quit for the day. -
ZBeing a 2wd a factory gov-loc or eaton M would be your best choice for true traction. If was 4x4, would still be best choice over a full...
-
ZSo I'll just throw in my 2 cents for what it's worth. When I first built my truck I used a warmed over 5.3 (~425hp) and a 4L65E out of...
-
ZZelph replied to the thread I finally got my hands on a squarebody!.Howdy. That’s a good looking truck.
-
ZZelph replied to the thread What locker shall I go for?.The Detroit unlocks when the driveshaft stops putting power into it. Turn a corner while pressing the throttle and it stays locked...
-
ZThe bulb seal fits over the pinch weld the front header seal I believe glues on and has a screw in each end as shown. I haven't had my...
