YakkoWarner's latest activity
-
YYakkoWarner replied to the thread 88 Suburban Barn Door Alignment.I used the LMC weatherstripping on my doors and they do close/latch, but I do get a small drip right at the top center when it rains and...
-
YYakkoWarner replied to the thread Engine oil lines..My 1989 big block has the factory oil cooler hoses attaching to fittings on the filter assembly not directly into the block, but the...
-
YYakkoWarner replied to the thread Parting 85 GMC.Do you still have the under-hood components for the cruise control (possibly not if it was engine swapped). I have all the under-dash...
-
YYakkoWarner replied to the thread 87 chev tbi, Vacuum canister? Timing advance?.Its one of the things I am missing!!! Ricko is right, it is part of the cruise control system - its a vacuum actuator that (when...
-
YYakkoWarner replied to the thread Update on my Ignition Module failure!.I grabbed an old Sears tach/dwell/voltage tester from a thrift store last year for the whopping sum of $4.00. Some wires were chewed up...
-
YYakkoWarner replied to the thread Gas in Oil!?.Can you get just a generic metal can filter with a simple barb on each end? My current British project has the glass filter (and...
-
YYakkoWarner replied to the thread Gas in Oil!?.I experienced this twice - once on a large GM 4 door car and once on a Jeep with a 2.5L GM engine. In both cases, the diaphram on the...
-
YYakkoWarner replied to the thread Black wire connected to indicator lamp.If it is actuallly a black copper wire and not the optical lead mentioned above, good chance it is a ground (possibly for all the...
-
YYakkoWarner replied to the thread headlight/seat belt buzzer.I get irritated by the old-school seat belt buzzers because sometimes I just want to sit in the truck with the heat or AC on and not be...
-
YYakkoWarner replied to the thread Whats your opinion these welders?.I have both a Hobart MIG and a PrimeWeld for TIG. I'm not real good with the TIG at this point, but have had very limited opportunity...
-
YYakkoWarner replied to the thread Grounding an Ignition control module!.I thought I had a problem with my ignition module ground - I put a small ring terminal on a length of wire, put that under one of the...
-
YYakkoWarner replied to the thread Changing brake fluid.I may start doing this on my Suburban if/when it comes back from the shop. It got a pretty solid front brake system flush when I did...
-
YYakkoWarner replied to the thread Stolen!.When I had to drive my British convertible to work in a less-than-steller area of the city I lived in at the time, I would disconnect...
-
YYakkoWarner replied to the thread Proportioning Valve and Bleeding.I have never been able to successfully vacuum-bleed anything on any vehicle. Gravity bleeding has worked sometimes if you can get it...
-
YYakkoWarner replied to the thread AFR GAUGE addition?.Now I want to know more about this MGB race car........
