Turbo4whl's latest activity
-
I picked up a bench top drill press, a little holder thing for gloves and a few paint guns in hopes of painting the Blazer in ‘25... -
Turbo4whl reacted to Ricko1966's post in the thread LE9 305 w ESC Performance upgrades '86 k5 Blazer with
Like.
Run a stock plug unless you are having a problem. Hotter plug more chances of preignition or setting off esc. Colder plug more likely to... -
Hey, Chris in Illinois here. Well, it appears this forum has been here a while but I just found it. I picked up :D an 86 K20 a few...
-
Turbo4whl replied to the thread Hello from western PA.There still is enough truck there to put it back on the road. 350s are a dime a dozen. Don't let the seized engine stop you. You can get...
-
Turbo4whl replied to the thread Gauge Cluster Swap.The 2 pin oil pressure switch is just for the choke. The oil pressure sensor or light switch is just one pin. Usually located at the top...
-
Besides moving pins to the correct locations, you will need a temp sender and an oil pressure sender to replace your temp switch and oil...
-
Turbo4whl reacted to Uberbeans's post in the thread Body swap on a c10 1981 to a 1985 k1500 with Like.
Yes I did a swap before and the years it really changes is between 80 to 81. I think your swap will work!
-
Turbo4whl reacted to Mr Clean's post in the thread Body swap on a c10 1981 to a 1985 k1500 with Like.
Yes
-
Thanks ^ Heads that's on it are the peanut port .. Found a set of 049 oval ports .. They are going to see some work done to em before...
-
Turbo4whl replied to the thread Custom made air cleaner housing for my verajet carb..Well it should have 250 on it! I also saw one online with flags but couldn't paste the photo. You would need to paint the 250
-
-
Turbo4whl reacted to LilRobert1367's post in the thread Custom made air cleaner housing for my verajet carb. with Like.
Build pic part 2
-
Turbo4whl reacted to LilRobert1367's post in the thread Custom made air cleaner housing for my verajet carb. with Like.
@legopnuematic yeah it's all hammer form. I will tell you especially the part that sits on the carb really tested my abilities.
-
Turbo4whl reacted to LilRobert1367's post in the thread Custom made air cleaner housing for my verajet carb. with Like.
I build a custom air cleaner housing for my 79 c20 250 with a verajet carb since I was unable to find one anywhere. I wanted it to look...
