Tank6x2's latest activity
-
Tank6x2 reacted to mxer147's post in the thread What have you done to your square lately?? with
Like.
Installed the rear wheel moldings. Cleaned up more old overspray blue paint, this time in the gas filler mounts. -
Tank6x2 reacted to Grit dog's post in the thread What have you done to your square lately?? with Like.
Damn! Looks familiar! Are you doing all dark blue or 2 tone?
-
Tank6x2 reacted to legopnuematic's post in the thread What have you done to your square lately?? with Like.
Moved the 76 back into the shop, it was hanging out in a friend’s unit while we did the work on his Dodge. Pulled it on the lift and...
-
Tank6x2 reacted to 82sbshortbed's post in the thread What have you done to your square lately?? with Like.
Got the quadrajet on and he's running like a champ! Had to do a little fabrication to the throttle cable bracket and carb spacer but it...
-
Tank6x2 replied to the thread What have you done to your square lately??.Nicely done
-
Tank6x2 reacted to Mr Clean's post in the thread What have you done to your square lately?? with Like.
Started the driverside rear section. Not done still have to finish the welding, but it's in a good place.
-
Tank6x2 reacted to 1lejohn's post in the thread What have you done to your square lately?? with Like.
Replaced the driver's side header gasket. It had been bad for a while. The truck sounds so much better now.
-
Tank6x2 reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
No if I were to take the truck to a mechanic at a garage to work on it is what I meant but I get what your saying, which is why I am...
-
Tank6x2 reacted to Redfish's post in the thread What have you done to your square lately?? with Like.
The only thing you need to apologize for is for letting your wife decide whether or not you can use your garage to work on your truck...
-
Tank6x2 replied to the thread What have you done to your square lately??.Took the bumper to work today and used some Oxy-Ace to reform the top edge, just a side project within a side side project - Hey Look...
-
-
Tank6x2 reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
Fought the old bolts for a bit then test fit one side still gotta drill the holes in the bumper to 5/8" but I'm liking the look so far
-
My ground is compacted road base
-
Tank6x2 reacted to Chris64's post in the thread What have you done to your square lately?? with Like.
Oh let's see... * Finally got my timing about right. * It finally starts and runs great...and... * Starter stopped working - tapped it...
-
Tank6x2 replied to the thread What have you done to your square lately??.Think I may of Killed the old 90° die grinder with 2” pads cleaning the door jam/ b pillar, just trying to push through the lack of...
-
-
Tank6x2 reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
I have this sitting around from a while back when I thought I was going to crawl under the truck and spray all the metal I could find...
