squaredeal91's latest activity
-
squaredeal91 reacted to CalSgt's post in the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC with
Like.
Great write up! I went through this when I did the L31 for the Squircle. Getting them apart with the oil varnish groove is a PIA, but... -
squaredeal91 reacted to RanchWelder's post in the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC with Like.
When it's time to re-assemble each clean dry piston, spring, plunger and stainless cap, make use of a hex nut driver, so you can squeeze...
-
squaredeal91 reacted to RanchWelder's post in the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC with Like.
Cleaning your roller lifters can go a long way to saving money on a rebuilt Roller Engine. First carefully remove the clips with a pick...
-
squaredeal91 replied to the thread Help ID-ing and sourcing a part.I was half asleep lol, Edit. Got pics? I think @legopnuematic nailed it
-
squaredeal91 replied to the thread GMC-IH.Another thought I had was with your race gear inside the pan maybe search forums about what the racers are doing for oil levels.
-
Not sure ?? I bought the pan off of eBay, didn't get a dipstick with it .. My concern is to not to over fill, want the oil to be below...
-
squaredeal91 replied to the thread GMC-IH.Too much oil above a certain level is not good. I would imagine go with original type dipstick because that would be correct engine...
-
How much oil does a boat engine contain? Wouldn't you match that? Or just match the full mark on the dipstick regardless if it takes...
-
squaredeal91 reacted to leejewell's post in the thread Saginaw 808 steering gear rebuild kit? with Like.
My 86 GMC is puking fluid from the steering input. I did some research and found that it is a Saginaw 808, 4 bolt. I can't find a...
-
Yeah they have floor grinders you can rent. They look like a floor buffer only with grinding stone blades under it. If you know...
-
79 Square C20 for sale, 350 with Edelbrock manifold and 600cfm carb. Granny gear 4 speed, new clutch. New interior and tilt wheel Heater...
-
I haven't happened across that info there yet. Even if GM did it on purpose, I'm going to change it, lol.
-
squaredeal91 reacted to RattleSnack's post in the thread Just bought this 87 square body in TN and it’s now home in North Carolina where i’m going to restore it with Like.
Looks like that truck you bought is in pretty good shape! I have a black and silver truck also....actually, it's gunmetal gray and...
-
squaredeal91 reacted to DJLarry's post in the thread Just bought this 87 square body in TN and it’s now home in North Carolina where i’m going to restore it with Like.
This is the Black and silver i’m looking for. And I’m looking to buy some deep chevrolet rally’s like these.
-
squaredeal91 reacted to DJLarry's post in the thread Just bought this 87 square body in TN and it’s now home in North Carolina where i’m going to restore it with Like.
Sorry guys I thought i posted a pic on my introduction post. i have attached a few here. it keeps saying image file too large ?
