squaredeal91's latest activity
-
Read up on the bushing and figuring I'll replace it as long as the trans is out, because it seems to be a common source of leaks on... -
squaredeal91 replied to the thread Intake manifold to head port mismatch.That must be what I was thinking of
-
Never overheated, but did have vapor lock issues which I addressed.
-
squaredeal91 reacted to 78C10BigTen's post in the thread Show me your lowered truck. The lower the better! with
Like.
Never knew they made a big 10 stepper, thats cool!! -
squaredeal91 replied to the thread Intake manifold to head port mismatch.I agree and am a firm believer with the if it ain't broke don't fix it reality and practice it myself. However I seem to remember...
-
squaredeal91 reacted to Catbox's post in the thread Intake manifold to head port mismatch with Like.
Not an issue. Run it all day long. The air in the runner will flow where it wants to be. Could it be better, sure. Will you notice the...
-
squaredeal91 reacted to fast 99's post in the thread Intake manifold to head port mismatch with Like.
I wouldn't think so. However, it would have more power [torque] with the correct intake.
-
squaredeal91 reacted to fast 99's post in the thread Intake manifold to head port mismatch with Like.
If it runs fine don't fix it. However, larger intake to smaller head port will be detrimental to performance. Square edge on head will...
-
I pulled the valve covers on the 454 and recorded the casting numbers on the heads. As I posted elsewhere recently, the engine is a 1971...
-
squaredeal91 replied to the thread 1984 c30 International DT466 Swap Questions.I'm into it. I got a 466 around for a possible pull truck. We'll see lol
-
squaredeal91 reacted to Biggnate81's post in the thread 1984 c30 International DT466 Swap Questions with Like.
I've seen a couple forums where a 466 has been swapped into a f350. Definitely some serious modifications required to get it to fit. As...
-
squaredeal91 reacted to bucket's post in the thread 1984 c30 International DT466 Swap Questions with Haha.
I'd be more concerned about getting it to fit. As for frame strength, it should be fine but that really would depend on what you plan to...
-
Installed LED's .... Ray Charles could see these bad boys ... !!
-
squaredeal91 reacted to rwtennent's post in the thread Show me your lowered truck. The lower the better! with Like.
78 Big 10 2 1/2" lowering spindles, 1' cut off the springs in front, flip kit in back. Measures almost exactly 4 1/2" in front and 6"...
-
squaredeal91 reacted to Scott91370's post in the thread Fix Slamming Doors - Striker Door Latch Repair with Like.
I used gray. Didn't like the blue or especially red on my truck.
