Rustisbest's latest activity
-
Rustisbest reacted to Ajax19's post in the thread What have you done to your square lately?? with
Like.
Other side bracket getting the holes drilled out made some funny looking notches in some leftover 2x3 tube to see if my idea works to... -
Rustisbest reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
-
Rustisbest reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
It's not much but I did get one side drilled out have to get a few longer bolts and some washers it's not perfect but neither is this...
-
Rustisbest reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
Not much happening today. Just picked the kid from school in the truck, drop off at Tae Kwon Do, then a fresh tank of ethanol free on...
-
Rustisbest replied to the thread What have you done to your square lately??.Just a shot in the dark but check to see what the coolant temp sensor is reading if you can get a scanner. May be reading low and...
-
Rustisbest reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
Doing a little research. I need to get my hands on an auto meter for setting base idle. Then I will need to adjust the timing in the...
-
Rustisbest reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
Keep at it man eventually you will find something awhile back I had a random sputtering and it was a combination of things one I had the...
-
Rustisbest replied to the thread What have you done to your square lately??.Got the bluetooth amp wired in and it sounds better than what I had in there so I'm happy with it. Without the AC ductwork in the way I...
-
-
Rustisbest replied to the thread Any explicit help on removing AC components and keeping heat?.You'll need a spot for the blower motor resistor too unless you just wire it on/off. Everything else can remain as is as already stated
-
-
Rustisbest reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
Drove the truck to my knee appointment after going one step leaner with the metering rods- big mistake! Way too lean. But interesting to...
-
Rustisbest reacted to Chevrolado's post in the thread What have you done to your square lately?? with Like.
Why is it the simple little things that are so entertaining to me... :D Got the rubber stopper (only one tab left on my tray) and new...
-
Rustisbest reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Like.
Forgot to post a picture Thursday. Loaded up a bunch of weight in the back just in case since this is my driver while my Z71 is down...
-
Rustisbest reacted to MPWILSON33's post in the thread Fuel gauge to tachometer, clock to fuel gauge with Like.
-
Rustisbest reacted to bucket's post in the thread 1996-2000 truck stock Cast iron exhaust manifold on 1985 C10 with Haha.
How is it that so many people think that headers only provide gains at high rpm? The fact is, it's quite the opposite.
