Ricko1966's latest activity
-
RRicko1966 replied to the thread Rear end gear ratio change or transmission change ?.You're 9 months late to the party
-
RRicko1966 reacted to legopnuematic's post in the thread 1976 Chevy Van G30 (Wayne Busette) turn signal switch with
Like.
Since they denote a tilt and non tilt option I’d assume there is a difference. Seems to be the lighted vs non lighted. I believe the non... -
RRicko1966 replied to the thread Gas to diesel.He only called you Francis,you should see what he called @fast 99 and @TotalyHucked
-
RIf it is a daily with very little towing, the 6.2/6.5 would be an easy swap. If you plan to pull a 65-100hp tractor regularly, I’d...
-
RI’m planning to install a higher output alternator to keep up with the electric fuel pump and dual electric fan radiator in my 75...
-
RIs this a new carb or known good? Or no idea the condition? Because if it’s a known good carb it will fire up with gas and vacuum. Not...
-
RRicko1966 replied to the thread Gas to diesel.Lots of people on this forumn have done diesel swaps,I'm doing one myself. Look in the engine swap section you should find plenty of...
-
RRicko1966 replied to the thread New Process A833 4speed w/ OD MY6 MM7.M22s and 833s wear out the countershaft bores on the m22s it causes a leak behind the bell housing,the cure is bore and bush the case...
-
RRicko1966 reacted to BigT's post in the thread Old man constantly asked to drop his truck.Any stock height C10s left in the world?? with Like.
I am a fan of stock height for the most part, so I'd leave it alone if it were mine. However, I only drive 4x4 trucks, and I treat them...
-
R............and all it takes is one backfire to blow a PV. If it's a Holley PV is bad/leaking, to those who dislike Q jets joking. I...
-
RRicko1966 replied to the thread Cylinders washed need help.I've always known about the transition circuit,people jack that one up all the time,but also assumed if the power valve was opened from...
-
RPower valves richen the main circuit, so unless your idling at 2500 rpm and the boosters are flowing a power valve doesn't affect idle...
-
RRicko1966 reacted to Catbox's post in the thread Quinn 8" needle nose pliers - Pinch da fug with Like.
Yup. After my first set of Knipex pliers, I don't use others.
-
RHave you ever thought that maybe he wanted a better ride, or to be able to haul motocross bikes or 4'x8' sheets with the tail gate shut...
-
RRicko1966 reacted to SquareRoot's post in the thread Need information on 22” Forgiato wheels on my c10 with Like.
OP joined the site and has ONE post. He gone. Hit and run. :Bye: Signature blocks says location: Texas. Engine Size: 305. I guess not...
