Ricko1966's latest activity
-
RRicko1966 replied to the thread SM465 Release Bearing Discussion.I think that point is just a pressure point where the fork has pushed in on the sheet metal 900 million times. As for the new one not...
-
RI was thinking this too. I have also seen where the light switch in the proportioning valve breaks off and jams the valve. If this...
-
RRicko1966 replied to the thread Need Help with Rear Brakes..I do it all the time,glad I'm not the only one.
-
RRicko1966 replied to the thread Need Help with Rear Brakes..Only reason I didn't go there,is he said he bled them with the centering tool in place. My gut said the same thing.
-
RWow! Are we back in 1997 now?! This is an awesome change of pace! The LT1 and LT4 swap was fairly common back in the 90's, but that was...
-
RRicko1966 reacted to Hunter79764's post in the thread Aftermarket EFI and dual internal pump tanks with
Like.
I'd think you would be in good shape using the factory switch to trigger a 30A relay for the pump, so that the switch is only handling... -
RHe's going off looks. They could have been bad for the past 99 years. Lol
-
RRicko1966 replied to the thread Need Help with Rear Brakes..Gravity won't work for sure if there's a residual pressure valve.
-
RGo back to post 4. If fluid can't be pushed to the rear there is a restriction. Proceed from the front to the back breaking lines loose...
-
RRicko1966 replied to the thread Time for new shocks. Look at these!.Clean the old ones up look for numbers,buy the exact same thing,those ones lasted,like 100 years.
-
RRicko1966 replied to the thread No power at temp gauge.Did you check either of them hot? Did you check continuity sender to head?
-
RIf the rear brakes shoes are not adjusted out to the drums, then you will have trouble bleeding the rear cylinders. Remember the (self)...
-
RIf the lines are clear verified with air from the master to rear cylinder bleeders either the master is bad or improper bleed procedure...
-
RSo, an '85 K20 was not available with a 454 from the factory. Before deciding the best course of action for the needs, you need to...
-
RRicko1966 replied to the thread LT1 Swap Vendorss?.I'm going to follow your.build probably going to have questions for you. How do you plan on pulling the engine out of the Van? I've only...
