Ricko1966's latest activity
-
RRicko1966 replied to the thread ‘87 454 TBI, NO Fuel spray, HAS fuel pressure, has 12v @ injectors, has spark.Did you ever check the fuse circuits as on post #7. If you are missing a power to the ecm that would explain a lot.
-
RRicko1966 replied to the thread 1978 k25 stalling issue.Maybe we'll be here.
-
RRicko1966 replied to the thread 1978 k25 stalling issue.It's not your lock cylinder or the ignition switch if you have good voltage at the HEI when it dies. If you are uncertain take a piece...
-
RWhen you get done shot gunning the problem we will still be here.
-
RBefore tossing parts at it why not try diagnosing first? As suggested above check fuel pressure and volume. Ethanol is not friendly to...
-
RAnd yes that is a square body Burb rear bumper, parallel to the fender. I have two, this one has the brackets and license plate holder...
-
RRicko1966 replied to the thread Oil Leak Into Cab.Covered back in post 8 and 9. Yep, it's not common,but it happens. I fully believe that the oil is pushed, by the oil pressure and uses...
-
RRicko1966 replied to the thread Parasitic draw.QUOTE="Uberbeans, post: 939519, member: 41860"] Ricko1966, are you saying that a bad alternator could cause a draw? Even if the...
-
RI am not an electrical guru but can promise you from experience on a 79 Trans AM that, yes, it can. It would drain the battery in 12...
-
RWay back we ran short track, 1/4 & 3/8 mile street stock cars. A Ford 9” was the perffered rearend. We’d weld a tall 1” vent about half...
-
RI wonder how many axels are out there filled with too much gear oil because of these aftermarket covers and the purchasers thinking more...
-
R80W-90 GL5 is what I have in my 79 and the 14b sf I built for a friend. Both have Yukon Dura-grips in them and that is what they recommend.
-
RI need to change the gear oil in the 84's 10 bolt. Now that I now how to fill it, what type of gear oil should I use? Isn't it 80w-90?
-
RRicko1966 reacted to 68post's post in the thread Idle Mixture Screws Do Not Adjust Anything on 1974 454. with
Like.
If you bought a "brand new" quadrajet then it is the problem (only chinese are making them, and not correctly), if it's a commercially... -
RRicko1966 reacted to Matt69olds's post in the thread Idle Mixture Screws Do Not Adjust Anything on 1974 454. with Like.
Fix the obvious things first, starting with the vacuum advance. While the distributor cap is off, make SURE the distributor weights...
