Rickf's latest activity
-
Rickf replied to the thread Bed swap issues?.If you center the rear axle in the wheel well opening, there will be a larger than "normal" gap between the bed and cab. -
Rickf replied to the thread UPGRADE BRAKES on a 79 K25.With larger rotors, matching calipers & brackets, you may need a larger size wheel & tire combo.
-
Rickf replied to the thread Engine Crossmember Replacement.Depending on what part of the north east you are located, where the truck came from and how much road salt was used, frame parts may be...
-
Rickf replied to the thread Spark plug gap closed fresh rebuild.Get one of those economical (cheep) scopes and take a look at the top of the piston.
-
Rickf replied to the thread 350 sounds like a diesel engine.Drain the oil look for "glitter" and cut the oil filter open and check for metal particles.
-
Rickf reacted to SquareRoot's post in the thread 81 k2500 vbelt to serpentine belt and upgraded alternator wiring troubles with
Like.
I'm no Sherlock Holmes but I'm speculating there's a question in there somewhere? What alt are you running? I converted to serpentine... -
Rickf replied to the thread Vintage Air Gen V (5) or replace existing compressor, etc., for 1987 R20 Suburban?.I put a vintage air R134 a/c system in my mid 80's CUCV blazer many years ago. It would do ok for the front but not for the rear...
-
Rickf replied to the thread Driveshaft too short after lift?.Before you have the driveshaft lengthened take the cap off the end of the yoke and check the condition of the seal/packing. If needed...
-
Agree with above, although 4” lift and K20 “should” be ok as is. At least comparing to my truck. But your pic, it appears you’re...
-
I've tried to stay out of this, but I really don't think this will be a big deal,considering it's 4wd. I'd take some inch and a half x...
-
Rickf replied to the thread Running Hot at Highway Speeds with A/C On.An excessive number of bugs committing suicide and plugging air flow through a/c condenser and or radiator.
-
Rickf replied to the thread Flywheel tooth count.Does the offset starter bolt pattern indicate the flexplate tooth count?
-
Not factory. Looks like a y fitting. Most likely for fuel.
-
Rickf replied to the thread What is this please!.Looks to be missing the pressure gauge.
