Raybob9289's latest activity
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.Lunch Debreifing; I went back to the adjustable engine mounts. Moved the engine 2" forward. NV4500 shifter is now easily out of the way... -
-
The ORD mounts will place the rear of an LS block in the same place as the SBC block...
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.The 454 clutch fan?? I'm using the screw on clutch fan from the 6.0 out of the the Burb
-
From experience (not the LS) I would move it forward and have at least an inch from the firewall. The shifter is gonna require a new...
-
Raybob9289 reacted to hoagster's post in the thread LQ4 Swap, starter wire routing question with
Like.
Try this again, You also have the battery wires running in the same spot, There is a protection plastic cover that attaches in the... -
Raybob9289 reacted to Drauka99's post in the thread 1981 C10, 6.0 LQ4 swap with Manual Trans Exhaust Question with Like.
Ok so on the passenger side, using the stock manifolds. you can get flanges from summit. I used those. One ear on the passenger side...
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.I'm only worried about the NV4500 shifter position and making sure the stock 6.0 fan fits in the original 4 core fan shroud. I'm...
-
before you put your engine in , take the valve cover off and remove the the damn oil filler neck You can now choose to use it if you...
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.it's really close only on passenger side cylinder head
-
-
I can maybe fit a 3/8" ratchet with a standard depth socket on it behind my engine(LQ4) to firewall. I used the ICT brackets for sbc to...
-
YES, Yellow COORS, breakfast of champions
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.Several test fits. Went with the ICT mounts but it seams like the engine is really close to the fire wall? Has anybody else done this...
-
-
Raybob9289 reacted to nvrenuf's post in the thread How to switch from a DRW to a SRW in a 1981 K30 / 350 engine / 3 speed manual / 4x4 with Like.
The front is easy - Buy some single wheel bearing hubs and install them. The rotors are technically different part numbers but the...
-
When I did my swap in the 73, I put in on the drivers side inner fender and the moved the battery above it. I can access it easily. I...
-
Painted and installed. this might be as close to a GMC Desert Fox as I'm going to get.
