pinballlarry1's latest activity
-
pinballlarry1 replied to the thread Got bored and started on the door renovations..Very happy with what I see down inside the door, some dirt and the small mirror reinforcement that I read about. Out it goes. Oops... -
-
Got bored and had some time so I decided to start on the passenger's door renovation. Not taking it all the way apart, just enough to...
-
-
pinballlarry1 replied to the thread Mud Tires.My '81 6 cylinder can chirp the rear tires when unloaded, but burnouts will never happen. Very happy with the look and overall...
-
-
pinballlarry1 replied to the thread What have you done to your square lately??.I would have loved to add the factory tach, but decided it was more than I wanted to try to do before winter hits. Never know about next...
-
pinballlarry1 reacted to PeteJr's post in the thread What have you done to your square lately?? with
Like.
Looks really good, Larry !. When I redid my gauges I added a tach and a smaller fuel gauge down to where the clock was on mine. I put... -
pinballlarry1 reacted to bucket's post in the thread What have you done to your square lately?? with Like.
I wouldn't add a stop-leak. There's really no magic fix for a radiator with plastic tanks. Imho, just buy one from a local parts store...
-
pinballlarry1 replied to the thread What have you done to your square lately??.Finished up reassembly of the dash, it looks nice: Of course, I had to fix the fuel gauge, it did not function after I put the clear...
-
-
pinballlarry1 reacted to Johnny Atomic's post in the thread What have you done to your square lately?? with Like.
Here's what I did my square lately. I drove it 900+ miles round trip to C10 Nationals in Nashville with my daughter. We had a great...
-
EVERYONE QUIET!!! Its official. The nays were wrong, I have the receipts. Although this is for Australian right hand drive, its...
-
pinballlarry1 posted the thread Installed new plastic/aluminum radiator, it works but....... in Engine & Performance.Needed to make some minor modifications to get the upper clamps on. My original brass/copper radiator had too many leaks for the...
-
-
pinballlarry1 reacted to Doppleganger's post in the thread What have you done to your square lately?? with Like.
After 2 yrs of delays I finally got my cab into primer. Also sprayed the hinges and a block off panel for the passenger side firewall. I...
-
pinballlarry1 replied to the thread What have you done to your square lately??.Also finished up the instrument panel modification for the lighting switches and choke knob I did last month. As purchased, no idea why...
-
-
pinballlarry1 replied to the thread What have you done to your square lately??.The wind last night was enough to blow out the plastic bow tie from my grille emblem. I sh#t you not: We had a storm blow thru for...
-
-
pinballlarry1 replied to the thread May be beating a dead horse here, but any source for clutch rod inner/outer floor boots?.The above rubber boot arrived today, it looks nice and will probably work. It looks to be almost identical to the original: It does...
-
-
Man even NOS or stainless steel should be cheaper than that....1/4-20 threaded rod, usually comes in a foot long stick, just cut to measure.
