pinballlarry1's latest activity
-
pinballlarry1 replied to the thread What have you done to your square lately??.Finished up reassembly of the dash, it looks nice: Of course, I had to fix the fuel gauge, it did not function after I put the clear... -
-
pinballlarry1 reacted to Johnny Atomic's post in the thread What have you done to your square lately?? with
Like.
Here's what I did my square lately. I drove it 900+ miles round trip to C10 Nationals in Nashville with my daughter. We had a great... -
EVERYONE QUIET!!! Its official. The nays were wrong, I have the receipts. Although this is for Australian right hand drive, its...
-
pinballlarry1 posted the thread Installed new plastic/aluminum radiator, it works but....... in Engine & Performance.Needed to make some minor modifications to get the upper clamps on. My original brass/copper radiator had too many leaks for the...
-
-
pinballlarry1 reacted to Doppleganger's post in the thread What have you done to your square lately?? with Like.
After 2 yrs of delays I finally got my cab into primer. Also sprayed the hinges and a block off panel for the passenger side firewall. I...
-
pinballlarry1 replied to the thread What have you done to your square lately??.Also finished up the instrument panel modification for the lighting switches and choke knob I did last month. As purchased, no idea why...
-
-
pinballlarry1 replied to the thread What have you done to your square lately??.The wind last night was enough to blow out the plastic bow tie from my grille emblem. I sh#t you not: We had a storm blow thru for...
-
-
pinballlarry1 replied to the thread May be beating a dead horse here, but any source for clutch rod inner/outer floor boots?.The above rubber boot arrived today, it looks nice and will probably work. It looks to be almost identical to the original: It does...
-
-
Man even NOS or stainless steel should be cheaper than that....1/4-20 threaded rod, usually comes in a foot long stick, just cut to measure.
-
Ace hardware
-
pinballlarry1 replied to the thread New Member in Eastern Montana.very nice truck, welcome from Kalispell!
-
This is just wrong....
