Old Guy Bill's latest activity
-
Old Guy Bill reacted to Grit dog's post in the thread 86 1/2 ton gears needed for 33” with new 383 with
Like.
Ya doesn’t make sense and I could be wrong but lotsa crazy stuff in the 70s/80s in the name of emissions and fuel economy. Thats just... -
Old Guy Bill reacted to TotalyHucked's post in the thread 1977 factory installed roof antenna, with Like.
Yep, that's aftermarket. Could've been dealer installed before the truck ever even left the lot, but definitely not factory
-
Old Guy Bill reacted to bigcountry78's post in the thread 1977 factory installed roof antenna, with Like.
I’m going to say that’s an NMO antenna mount, for a cb or public safety antenna. I don’t think GM ever did a factory roof antenna. The...
-
Old Guy Bill reacted to legopnuematic's post in the thread 2005 Ram 2500 Free Spin Install & Other Goodies with Like.
Thought I would make a thread detailing some work I’m helping my friend do on his 2005 Ram 2500, QCSB, 5.9 Cummins, 4x4. A little...
-
Old Guy Bill reacted to Grit dog's post in the thread What have you done to your square lately?? with Like.
There’s a reason I NEVER took on a resto project ever, until the blue truck. It would have been in pieces for years! Couple scuff n...
-
Set the valves just like it was a fresh build. Run it on the floor. Leave the valve covers loose. Wait a couple of minutes and run the...
-
above or lifters that have bleed off or worn out internally. Sometimes takes while to get all the air out of lifters even with engine...
-
Take the rocker arms, push rods and lifters out and inspect the cam lobes to see if they're wiped. You can also inspect the lifters...
-
Sho does, Lisle is good stuff. I've got the Snap On version of that and the only difference is the handle. :insane:
-
Old Guy Bill reacted to 75BEASTK20's post in the thread What new tools have you got lately? with Like.
I think mine should be in the poverty section. Flywheel turner.
-
Got my Dad a new vice for Christmas
-
Old Guy Bill reacted to TotalyHucked's post in the thread What new tools have you got lately? with Like.
Also picked up some new tools to make the regear easier on the NBS Race/seal installer Bearing puller/installer Tool for front diff...
-
Your life will be forever changed @legopnuematic !
-
Old Guy Bill reacted to legopnuematic's post in the thread What new tools have you got lately? with Like.
Got everything torqued and double checked, leveled it with a stick rule and laser level, within a 32nd of an inch corner to corner. Then...
-
Old Guy Bill reacted to legopnuematic's post in the thread What new tools have you got lately? with Like.
Progress report on the lift install. Got started on it a lot later than I wanted to as I had put that other Dodge parts truck up for...
