Old Guy Bill's latest activity
-
Old Guy Bill reacted to Doppleganger's post in the thread What have you done to your square lately?? with
Like.
I had never touched a steering box til mine. There are a few really good vids out there - found that mine was missing parts as I got... -
^^^ This^^^ If a hood latch is out of adjustment, the pressure from the spring can cause the latch to bind more. When you finally get...
-
Old Guy Bill reacted to codfish's post in the thread door lock cylinder not working on passenger side with Like.
SUCCESS!!!! I ordered new door lock pawls from Tuckers. A left and a right. THEY are the parts that are side specific. Clocked...
-
Old Guy Bill reacted to 87scotty's post in the thread This one needs to go, asking for opinions. Offering it up here first. with Like.
100% I'll rebuild/swap a motor way before putting bedsides Floorplan cab corners ect.
-
Old Guy Bill reacted to Robert Bare's post in the thread This one needs to go, asking for opinions. Offering it up here first. with Like.
Well, street unusable and illegal, and a incomplete project. May have to cut your losses and run. BUT, selling prices are all over the...
-
Old Guy Bill reacted to Robert Bare's post in the thread Press-in rocker arm studs migrating up. with Like.
You changed geometry and probably tension. You should have went to screw in studs. BUT, in the old days, we drove them back in, drilled...
-
Old Guy Bill reacted to idahovette's post in the thread Press-in rocker arm studs migrating up. with Like.
Back in the day....WAY back, when I worked at the Chevy/Cad dealer, GM had a special tool that was a Rocker arm stud installation tool...
-
Old Guy Bill reacted to Leadfootc20's post in the thread Does anyone know if i have a 1 piece or two piece vent window? with Like.
I did exactly the same thing to mine when installing a new window handle (incorrectly). It looks exactly like mine (which is a...
-
Newbie from Sweden saying hej Currently have a Suburban C10 from 1982, i have tons of question but start by looking at existing...
-
If used only on occasion, remove the battery. Do as i say, not as i do. I use Fluke
-
Good luck Sir! Tilt column’s are tricky but kinda fun too
-
Piece of trash in the cylinder Dry cruddy grease in the rack assembly Broken rack Bent ignition rod Worn out/damaged switch Combination...
-
And for the rest of the crowd, that principle applies to many things. If you halve the constraints, you halve the potential for error.
-
It will be an ACDelco R45TS. That was the specified plug for almost every small block(and some big block) GM engine for decades. My 71...
-
Old Guy Bill reacted to Craig Nedrow's post in the thread I would really like a turbo 400 in my truck with Like.
The first gear ratio of a 700r4 is a steep 3.06, the TH400 and 350 are right at is 2.52, depending on where you get your info. 4L80e are...
