Old Guy Bill's latest activity
-
Can op show us your setup? a stock iron manifold for a qjet with an adapter with the 1406, it would be easy to put a ASV2 on since it... -
Really sounds like a hot soak problem. Check fuel pressure and float setting. If that's ok try non-ethanol fuel. I have the same issue...
-
Old Guy Bill reacted to TotalyHucked's post in the thread 1985 Long Bed Floor and Bedsides with
Like.
Yeah and alot of the squarebody panels were junk for a long time, what we refer to as "crash parts". We reverse engineered off good... -
I think I'd get out a flap disc/one of those paint remover drum things and strip what you have before going any further. Certainly won't...
-
This is the type of seal I'm referring to. " Upgraded 14 bolt hub seals. If you have constantly leaking hub seals or a pitted/damaged...
-
I fixed it today it works perfectly
-
Tilt column has that added feature of having an extra place to get loose and become a general pain in the a$$. It's not uncommon for...
-
Old Guy Bill replied to the thread Rear axle seal questions..The seal areas on mine cleaned up good with emory cloth. I used the $$ pricey double lip seals from ORD. Time will tell…
-
Old Guy Bill reacted to legopnuematic's post in the thread Looking to swap a 1979 Bonanza to an Automatic Overdrive with Like.
If you go with a 700r4, an NP208 would probably be the easiest solution as they are rather plentiful and came behind 700r4s from the...
-
Old Guy Bill reacted to Nasty-LSX's post in the thread I would really like a turbo 400 in my truck with Like.
I'm swapping to a 4l80e I NEED overdrive. I have a perfect TH400 that needs no rebuild. No slipping skipping or weird stuff if your...
-
Old Guy Bill replied to the thread I would really like a turbo 400 in my truck.Middle one, bottom row. The new ones sold by Jeggs & Summit are for drag racing and have no provision for turning the Governor.
-
-
Old Guy Bill replied to the thread I would really like a turbo 400 in my truck.I just changed the 203 to a 208 behind my TH400. A 6-7” tail shaft is needed, I could only find a good used one from Novak.
-
Old Guy Bill reacted to Doppleganger's post in the thread What have you done to your square lately?? with Like.
I mounted the block off panel for all the heater core holes I wont need anymore. Used 3M panel adhesive with 1/8" screws to hold it in...
-
Trucks n Tacos in Long Beach.
-
MMMMMM… Waffles!
