Old Guy Bill's latest activity
-
This thread is epic! Both entertaining and disappointing. A Mad Ogre proclaiming he's not stupid and a whole thread on axles without one... -
Gotta admit, not too shabby thanks guys
-
Yes, that's what most of the trucks had for wheel arch moldings. However, '77 trucks had yellow instead of black. And the bigger...
-
That is exactly how they came from the factory. The plain chrome ones were aftermarket. I ordered a full set from LMC and they were...
-
Old Guy Bill reacted to yellow eyed Andi's post in the thread Andi from Hannover/Germany with my 1985 C10 Stepside named "Daily-Blue1" with
Like.
Hello, i am the yelloweyed Andi...iam 61 years old... yelloweyed...because i am wearing yellow glasses... i bought my Daily-Blue! a... -
Old Guy Bill reacted to SquareRoot's post in the thread Why doesn't anyone use the Chevy "Connect & Cruise" packages? with Like.
That's how I'm doing my next build. When I find a clean 89-91 K5, I'm dropping it off at Danny's (aka the Count) in Vegas, telling them...
-
Old Guy Bill reacted to SquareRoot's post in the thread Bubbling feel of throttle at low RPM with Haha.
Bent aXLe
-
Old Guy Bill reacted to Ricko1966's post in the thread Bubbling feel of throttle at low RPM with Haha.
LS swap, your turn.
-
The normal chambered type are available in stainless as well. When I quoted that post, I tried to be as nice as possible. What I...
-
The same ones that are the worst for traction.
-
@legopnuematic beat me to it but here’s another, also a picture of the skids I built to hold my cab until the bodywork was done and it...
-
That's not a button it's a rubber dust cap that seals the valve, don't eff with it,you can't get a new one.And I'd try centering the...
-
The fronts are at the intersectionthe cab support and brace that runs to the inner rocker.
-
If your goal is just a fun weekend/occasional cruiser and you wanna be budget friendly, a warmed over 350 would definitely be the...
-
Basically same as valve float. Inability to control opening and closing. Solving point float sounds easy, increase closing spring...
