NickTransmissions's latest activity
-
NickTransmissions replied to the thread 4L80E Information Thread.Expect to see upwards of 300-350PSI in reverse at middle-to-higher throttle angles; about 220-275psi in Drive at the same T angles. -
NickTransmissions replied to the thread 4L60E Information Thread (Includes 4L65/70/75).Try it if you want but be prepared to do the job twice if it doesnt work out. Or simply get the correct pump body for that 05 case -...
-
NickTransmissions replied to the thread 4L60E Information Thread (Includes 4L65/70/75).5KCD indicates a 2005 unit/case so you'll need to grab a 2004+ pump body that does not have an O-ring groove on the outer diameter if...
-
NickTransmissions replied to the thread 8l90E trans shudder.You swapped an 8L90 into a Squarebody truck? If so, good on you for doing it! Would be curious how you went about it (complete...
-
NickTransmissions replied to the thread TH400 Direct Drum/Sprag Question.Replace the torque converter - never reuse a converter!! It's tantamount to putting dirty clothes on a clean body after showering. My...
-
NickTransmissions replied to the thread Govoner.This issue is likely caused by a severely worn rear transmission case bushing. When the bushing is worn, it allows the output shsft to...
-
NickTransmissions replied to the thread 4L60E Information Thread (Includes 4L65/70/75).Ive been using those and similar valves for close to 15 years and so far, no issues but have heard/read other builders report those...
-
NickTransmissions replied to the thread 4L60E Information Thread (Includes 4L65/70/75).Those will all work but I like the Fitzall valve as it completely seals the bore and is appx $25.00. The others convert the PWM to...
-
NickTransmissions replied to the thread 4L80E Information Thread.Hi Vbb199 - please post your above question here: https://www.gmsquarebody.com/threads/4l60e-information-thread-includes-4l65-70-75.42240/
-
NickTransmissions replied to the thread Advice on Transmission Fluid Change for 1980 C10.The pan itself holds 4-5 quarts; the entire system holds like 8-10 (TH350/TH350C)... Anything DexMerc will be fine. If your TH350C (Im...
-
NickTransmissions replied to the thread Looking to swap a 1979 Bonanza to an Automatic Overdrive.You're welcome...I'm not sure on the t-case as that would depend on whether you had a driver side or pass side drop for the front diff...
-
NickTransmissions replied to the thread Looking to swap a 1979 Bonanza to an Automatic Overdrive.700R4 is the most straight forward and cost effective swap.
