Memaloose's latest activity
-
Memaloose reacted to Jgonick's post in the thread What is this wire and where does it go it has a grommet on it makes me think it would go to firewall with
Like.
Maybe----WHT-156 - runs to door jamb switch. Goes through side kick panel. It grounds the courtesy light & dome light so they will... -
Memaloose reacted to JD Miller's post in the thread RockAuto- 4x4 front drive shaft, '81 K20 -Rock Auto with Like.
I just received my new front driveshaft from Rock Auto for my '81 k20. I got the Dorman. Looks very good quality, and made in USA I'll...
-
Memaloose reacted to JD Miller's post in the thread RockAuto- 4x4 front drive shaft, '81 K20 -Rock Auto with Like.
Well , heck that's a Damn good Deal. Im in near a small town, closets DS Shop is hunert miles away and they want $350 to just replace...
-
Memaloose reacted to ali_c20's post in the thread RockAuto- 4x4 front drive shaft, '81 K20 -Rock Auto with Like.
I bought a Dorman 2 piece driveshaft for my C20 from Rockauto this year. Very good quality, all parts spicer and built on order. Local...
-
It would be easier to just wire an on-off and mount it to the original face plate. I didnt realize the motor being on with key on was...
-
1980 ad (not disputing terry just found thread in notifications )
-
I think the complicated "air" system this car had makes sense now with that blower motor thing running all the time, there is the valves...
-
Any square 1980 and earlier will not have an "off" setting for the blower. It will always run at least a little bit.
-
If you're talking about your '73, the blower always runs on LOW. It's part of the ventilation system.
-
Many GM vehicles have a blower motor that runs any time the ignition is on. For our trucks it varies by year, but I know it is...
-
Memaloose replied to the thread QJet Questions.A battery is better to test with than a charger.
-
Just aquired this bike today in a trade. It's a 2009 Honda, 250 Rebel with 4,900 miles on it. I took it for a short ride but didn't want...
-
-
I checked it out but it appears my issue is I may have the Throttle cable it doesn’t go back far enough to touch the kickdown switch...
-
If it’s close, slip a piece of rubber hose over the switch. You can also use a hose clamp on the switch knob. McGuyverism!!
-
I believe that factory TH400 cars and trucks did have an specific bracket that had provisions for the kickdown switch. I've looked into...
