Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
Registered members
Current visitors
Menu
Log in
Register
Install the app
Install
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Matt69olds's latest activity
Matt69olds
replied to the thread
Accelerator Cable Adjustment
.
How about some pictures of what you’re working on? What carb/intake, are you using? It might be quicker and easier to just buy the...
Feb 11, 2025
Matt69olds
replied to the thread
Th350 rebuild (lost drive gears)
.
The clutches have definitely seen some heat, but they aren’t burnt. What’s the pump look like?
Feb 8, 2025
Matt69olds
replied to the thread
Suburban Trans Pan removal help
.
Raise the transmission as high as possible, get as much clearance as possible between the pan and the crossmember. If that doesn’t...
Feb 6, 2025
Matt69olds
replied to the thread
Turbo350 w/shift kit slamming 2nd gear
.
Lube the seal with vasoline, place the o ring in the case, right up against the step it seals against. Lube up the cover, put it...
Feb 5, 2025
Matt69olds
replied to the thread
Whip antenna for CB on a Suburban
.
On a somewhat related subject: my wife and I like to go to flea markets, pawn shops and swap meets. One of the pawn shops I frequent had...
Feb 5, 2025
Matt69olds
replied to the thread
Whip antenna for CB on a Suburban
.
On my truck, I ran the coax from the center of the roof down the center of the rear window. From there is zip tied to the floor until it...
Feb 5, 2025
Matt69olds
replied to the thread
Whip antenna for CB on a Suburban
.
I use to be big into radio when I was a kid. My fascination started when dad bought a Buick Electra with factory am/fm and built in CB...
Feb 4, 2025
Matt69olds
replied to the thread
Need help wiring power windows and door locks 83 K1500
.
It helps being cheap! I grew up watching Scotty on Star Trek (the Miracle Worker!) and McGuyver. It ain’t broke if they can fix it...
Feb 4, 2025
Matt69olds
replied to the thread
Need help wiring power windows and door locks 83 K1500
.
GM used a screwed up complicated power door lock system in those years. It’s hard to explain, but pushing a button on one side uses the...
Feb 3, 2025
Matt69olds
replied to the thread
Smoking Ground Wire
.
I bet you will find either a loose ground wire, or bad corrosion inside the insulation of the heavy ground wire. Since the main ground...
Feb 3, 2025
Matt69olds
replied to the thread
Mechanical fuel pump return line
.
Yep, the lower the pressure (or vaccum) the lower the boiling point.
Feb 3, 2025
Matt69olds
replied to the thread
Old school garage door opener remote
.
That’s exactly what I’m planning to do. A block of wood cut to fit in the opener pocket, with a push button placed in the correct spot...
Feb 3, 2025
Matt69olds
replied to the thread
1976 Chevyvan G30 stiff accelerator pedal
.
Make sure the cable isn’t twisted or kinked, look for obvious damage. Unhook the throttle from the carb, does the carb throttle plates...
Feb 1, 2025
Matt69olds
replied to the thread
Mechanical fuel pump return line
.
The return setup would be preferred with today’s lousy gas. The 3 port pumps have a tiny orifice in the return fitting, basically a...
Feb 1, 2025
Matt69olds
replied to the thread
Odd Cooling System issue
.
Did the same thing on my first car (64 nova). I was 15, that’s a mistake you hopefully only make once!!
Feb 1, 2025
Latest posts
C10 Newbie
Latest: brooksman9
31 minutes ago
Introduction
Scores from DIY Parts Yards, Pull A Part, U Pull It etc
Latest: mxer147
56 minutes ago
Garage
Blower Motor not working
Latest: Jgonick
Today at 8:47 AM
Heat & AC
Forum statistics
Threads
45,308
Posts
980,364
Members
38,321
Latest member
verbalist54
Members
Top