legopnuematic's latest activity
-
legopnuematic replied to the thread 6 Lug to 5 Lug Conversion.I’d reckon they swapped the axle shafts, should able to use a, say 1972 C10 axle shaft. Both 12 bolt truck axles, widths should be the... -
Any paint and body supply can match it. But I’ll throw out another plug for Tamco paint. Still a great value. That said, @Stormhawk...
-
Thank you for your input. Your comments are exactly what I was looking for. Unless someone out there has a compelling argument that...
-
Another thing to look into for a small vibration (especially if it comes and goes) is wheel runout and tire balance. That's something...
-
legopnuematic replied to the thread rock auto discount code for 10/24 to 11/8/24.All the RockAuto codes I’ve used have been 5%, also if you ship to a commercial address, shipping is a fair bit cheaper.
-
legopnuematic replied to the thread 6 Lug to 5 Lug Conversion.Honestly, in my opinion, not worth it. You would be going from a 10 bolt to a 10 bolt. I’m not sure, but I’d suspect the limited slip...
-
legopnuematic replied to the thread k35 from Fresno, greetings all.Welcome from Missouri.
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with
Like.
Finally got back on this and finished up the rear axle for good today. Pulled the carrier out one last time to grind down that one tooth... -
legopnuematic replied to the thread Hello Howdy!.Welcome from Missouri.
-
Don't hold me to it but I don't recall it having them in either the top or the bottom. K
-
Well done, Lego. Just to flesh it out a bit more: I see C20903 W LT9 with the three speed auto (non overdrive = MX1) so I'd call it...
-
legopnuematic reacted to bucket's post in the thread 1996-2000 truck stock Cast iron exhaust manifold on 1985 C10 with Like.
How is it that so many people think that headers only provide gains at high rpm? The fact is, it's quite the opposite.
-
legopnuematic replied to the thread Axle ratio help.Or pop the rear cover and count the teeth/find the numbers on the ring gear to verify. If you haven't changed the gear oil in your...
-
-
I'm a little late to the game, but here's a good video (down the webpage a little) on how to crimp those Packard/Delphi terminals. Watch...
-
legopnuematic replied to the thread Hi - from Upstate, SC.Welcome from Missouri.
