Keith Seymore's latest activity
-
Keith Seymore replied to the thread Figuring out which Speedo gear I need for my vehicle. help!.As far as the speedo not working - you can pull that little housing and slip the gear out. You would be able to buy that same gear... -
Keith Seymore replied to the thread Figuring out which Speedo gear I need for my vehicle. help!.That is quite a machine. To get the rear axle ratio: a) For open rear diff - mark the tire and drive shaft. Jack up one tire and...
-
Keith Seymore replied to the thread Figuring out which Speedo gear I need for my vehicle. help!.A few comments: a) Pics? b) I don't think the fact that it is a busette makes any difference. A 700R4 is the same regardless of what...
-
Keith Seymore replied to the thread Rear End Gearing.Hopefully you are not in a big hurry. I ordered mine back in November and the parts are just now starting to trickle in. (I'm not in a...
-
Keith Seymore replied to the thread Rear End Gearing.Yep. 3.70 will be a nice overall ratio with an OD trans. K
-
Keith Seymore replied to the thread Master cylinder ID help needed.For 1983 the base manual system is JB1 and the master cylinder is part number 18006064 broadcast code CU. Built in Oshawa makes no...
-
-
What is the torque rating on the 6.6? I have done A LOT of heavy towing with '03, '05, '06 and '07 Duramaxes. They pull good and they...
-
Keith Seymore replied to the thread What is my new squarebody??? Need help!.1GCGD34J2GF394406 decodes to 1986 model year, where G = 1986 F = Flint Assembly 394406 = serial portion of VIN I might have put the...
-
Keith Seymore replied to the thread C10 GEARS?.I usually do 3.73:1 with overdrive trans; 3.42:1 with non overdrive. K
