KCKKen's latest activity
-
KMy buddy used what Ricko1966 is talking about, Magnet paints chassis saver on the dump truck, and the 4by frames, and it has held up...
-
KHi Everyone! It's time for it to go - 1985 GMC, originally had a V-6/TH-400 but now has a locked-up 350 from the 70s in front of the...
-
KKCKKen reacted to DoubleDingo's post in the thread Hightly Suggested for BUYERS (Read First) with
Like.
Also, please be aware, that the hacker can also PM. Be careful, unless you are certain it's legit. -
KKCKKen reacted to Mr Clean's post in the thread Hightly Suggested for BUYERS (Read First) with Like.
With the recent hacking we have had, we would suggest PMing phone numbers to one another to help insure the sale is legit. If you don't...
-
KKCKKen reacted to CheemsK1500's post in the thread Definitive interchangeable parts thread 73-87(91) (non-drivetrain) with Like.
Quick note about about DoD contract built CUCVs: The M1008 pickup is essentially just an ‘84 K30 Custom Deluxe with a 24 volt NATO spec...
-
KKCKKen reacted to CheemsK1500's post in the thread Definitive interchangeable parts thread 73-87(91) (non-drivetrain) with Like.
Here’s a quick little list of trim/moulding compatibility list: Front wheel well opening trim can be shared between the 73-80 years...
-
KKCKKen reacted to CheemsK1500's post in the thread Definitive interchangeable parts thread 73-87(91) (non-drivetrain) with Like.
Perhaps the presence of vent cutouts on non-ac truck pads depended on year. It would make sense for GM to transition installing vent cut...
-
KKCKKen reacted to legopnuematic's post in the thread Definitive interchangeable parts thread 73-87(91) (non-drivetrain) with Like.
I suspected you meant the pad itself, wanted to verify. I don’t believe any dash frames were stamped without vent holes. As far as...
-
KKCKKen reacted to CheemsK1500's post in the thread Definitive interchangeable parts thread 73-87(91) (non-drivetrain) with Like.
In this thread we can try to make a list of what fits what or what modifications are needed for something to work or look "correct."...
-
KI will have to look into the bezels, I could use a couple. When I bought my first square here in AZ, there was a "store" in Tempe AZ...
